User manual MORPHY RICHARDS IB41540

[. . . ] Do not allow the cord to touch hot surfaces. Let the iron cool completely before putting away. Loop cord loosely around the iron before storing. To protect against the risk of electric shock do not put the appliance in water or in any other liquid. [. . . ] If you turn the control dial down from a hot setting to a cooler setting, wait until the iron temperature has stabilised before you continue ironing. 3 Replace the water inlet cover before using the iron. WARNING: Never use battery topping up fluid or water containing any substances like starch, or sugar, or defrosted water from a refridgerator. 4 Always pour out the remaining water after use. WARNING: When filling your iron with tap water always use the beaker provided. Never fill directly under the tap. Temperature control Plug in the iron and switch on. Set the temperature control dial ¤ to the temperature required, but don't start ironing immediately. If you wait a few minutes, the iron will stabilise at the required setting. It is always a good idea to begin with 'cool' fabrics and work up to higher settings. An iron heats up quicker than it cools down so you'll save time and electricity. Filling 1 Before filling the iron with water, ensure the iron is unplugged and the steam control is set to . Pull the water inlet cover out and pour water through the filling hole into the water tank using the beaker provided. Three cups (75ml) of water will fill the tank. In hard water areas the use of distilled or demineralised water is recommended. 2 5 41540 Rev 1 1/6/04 12:00 PM Page 6 Features of your iron The indicator light < shows that the iron is warming up. When the required temperature is reached the light will go out and will cycle on-off during operation. This shows that the iron is maintaining the heat setting you have chosen. Surge of steam Push in the surge button to obtain a boost of extra steam for ironing out creases in heavy material such as denim etc. The shot of steam can be used whilst dry ironing, providing there is water in the tank, and the temperature control is set to the steam position. Do not use the surge of steam at temperatures below the steam position shown on the control dial. Note: For optimum steam quality, do not operate the shot more than 3 times in succession. Dry ironing only You can also use your iron as a dry iron only. Make sure the steam control is set to the no steam symbol . Any temperature setting may be used depending on the garment. You do not need to put any water in the tank when dry ironing only. Steam control Fill the iron with water as described in `Filling', (page 5) and insert the plug into the electrical socket. Turn the temperature control dial, to the `steam position' shown as and rest the iron on its heel whilst it warms up. Turn the steam control fl to the steam position . [. . . ] If for any reason this item is replaced during the 2 year guarantee period, the guarantee on the new item will be calculated from original purchase date. Therefore it is vital to retain your original till receipt or invoice to indicate the date of initial purchase. To qualify for the 2 year guarantee the appliance must have been used according to the manufacturers instructions. For example kettles should have been regularly descaled. EXCLUSIONS Morphy Richards shall not be liable to replace or repair the goods under the terms of the guarantee where: 1 The fault has been caused or is attributable to accidental use, misuse, negligent use or used contrary to the manufacturers recommendations or where the fault has been caused by power surges or damage caused in transit. [. . . ]