User manual MORPHY RICHARDS IB42345

[. . . ] (Check by plugging in another appliance). · WARNING: When not in use, your steam station should never be left on an ironing board unattended. · To prevent damage to the textile being ironed, follow the temperature guide carefully. (Test the inside of the hem of the garment). [. . . ] A fl fi < > / Steam on/off button ¤ Filling cap < Removable anti-scale cartridge > Anti-scale release button fi Water tank fl Power cord Temperature dial with indicator · Temperature indicator light , Supply cord , , Steam on/off indicator light Filling funnel Before use Note: The steam facility should only be used on garments which are suitable for ironing at the 3 dot setting. Clothes can be steam ironed at the 2 dot setting, but only for a short period. Textiles and clothes are supposed to carry ironing instructions. If they don't you should follow the fabric guide on page 3, but be sure to test the temperature by ironing the hem of the garment or similar area first. If you turn the control dial down from a hot setting to a cooler setting, wait until the steam station temperature has stabilised before you continue ironing. Temperature control Plug in the steam station and switch on. Set the temperature control dial on the iron B to the temperature required, but don't start ironing immediately. B 4 42345 Rev 2 31/5/05 9:39 AM Page 5 If you wait a few minutes, the steam station will stabilise at the required setting. Your Morphy Richards iron is fitted with an indicator light · which will go on and off while you are ironing. This is perfectly normal as it shows that the iron is maintaining the heat setting you have chosen. It is always a good idea to begin with cool fabrics and work up to higher settings. An iron heats up quicker than it cools down so you'll save time and electricity. Anti-scale system The anti-scale cartridge is designed to reduce build-up of limescale which occurs during steam ironing, this will prolong the working life of your steam station. However please note that the anti-scale cartridge will not completely stop the natural process of limescale build-up. Anti-scale cartridge replacement 1 Press the release button to the side of the cartridge. C C Features of your iron Temperature indicator light The indicator light shows that the iron is warming up. When the required temperature is reached the light will go out and will cycle on-off during operation. Dry ironing You can use your steam station as a dry iron only. Any temperature setting may be used depending on the garment. You do not need to put any water in the tank when dry ironing only. 'Click' on - 'click' off steam button To activate the steam press the steam button / once and release. The indicator light , , will illuminate, indicating the iron is in steam mode. The first time you use the steam station, it will take approximately 30 seconds for the steam to start. Any noise will be due to the pump removing air from the system. [. . . ] 4 Where the appliance has been used for hire purposes or non domestic use. 5 Morphy Richards are not liable to carry out any type of servicing work, under the guarantee. 6 Anti-scale cartridges for all Morphy Richards irons, steam generators are not covered by the guarantee. This guarantee does not confer any rights other than those expressly set out above and does not cover any claims for consequential loss or damage. [. . . ]