User manual MORPHY RICHARDS IB42370

[. . . ] St gen rn42370M rev 3 31/5/05 10:10 AM Page 1 Steam generator Ironing system Please read and keep these instructions getting the best from your new steam generator. . . · Safety first Caution must be used when handling this appliance as it does get very hot. Always switch off the unit and allow to cool before cleaning or storing. · Boiler unit WARNING: The product produces steam which is pressurised. Never unscrew the boiler filler cap whilst the unit is pressurised. Steam will shoot out and could burn you. · Performance Every 3 months fill the boiler with fresh water (0. 8L), rinse then empty. [. . . ] 4 Fill the boiler, taking care that the water does not spill over. 5 Replace the boiler filler cap by screwing on but don't overtighten. If the filler cap whistles, it is not tight enough or the filler cap has not been positioned correctly. In this case switch off the boiler, allow it to cool, then reposition the filler cap correctly. 6 Take care not to overfill if the steam generator contains water. > < fl  , fi , , Á · Iron unit / Steam button ¤ Temperature control dial < Sole plate > Iron ready indicator light fi Supply cord from base unit Ê Steam on/off indicator light Base unit fl Filler cap Power cord · Power switch , Refill indicator (Boiler tank) , , Boiler ready light indicator Variable steam control  Iron/boiler selection switch Á Funnel for filling A Location Locate the steam generator horizontally 4 St gen rn42370M rev 3 31/5/05 10:10 AM Page 5 Using 1 Plug in at the mains socket. · Check to see the iron/boiler selection switch  is set to boiler. · Check to see that the steam on/off indicator light is 'off'. 2 Press the power switch · to the 'on' position, the indicator light in the middle of the switch will illuminate. Ensure that the iron temperature control ¤ is at the correct setting for the material you are ironing. 3 Turn the vari-steam control knob to the mid position as shown. B And set the temperature control dial ¤ to 3-dot. 4 Allow the boiler to heat for about 4 minutes. The generator will be ready to use for ironing when the boiler ready indicator , , illuminates and the iron ready light > on the iron goes off. · During ironing, the iron ready indicator and the steam ready indicator will cycle on-off. Textiles and clothes are supposed to carry ironing instructions. If they don't you should follow the fabric guide on the control dial of the iron, be sure to test the temperature by ironing the hem of the garment or similar area first. If you turn the control dial down from a hot setting to a cooler setting, wait until the iron temperature has stablilised before you continue ironing. 5 Important note: If the product is accidentally switched off while ironing the boiler controls require approximately 21/2 minutes to re-set before steam ironing can be resumed. Steam ironing 1 Ensure that you have filled the boiler correctly. 2 Consult the heat settings chart page 3, and select the position on the temperature control dial that corresponds to the fabric to be ironed. The iron ready light > illuminates and the soleplate heats up. Wait until the light goes out and the boiler ready indicator on the base unit , , illuminates before ironing. 3 To obtain steam, press the steam control button / and release, the indicator light Ê will illuminate. [. . . ] This feature is especially useful for getting creases out of hanging clothes, curtains, wall hangings, etc. Staple your receipt to this back cover for future reference. Please quote the following information if the product develops a fault. These numbers can be found on the base of the product. [. . . ]