User manual MORPHY RICHARDS IB43083

[. . . ] · Do not let the mains lead hang over the edge of the worktop where a child could reach it. · Do not let the lead run across an open space e. g. · Do not let the lead run across a cooker or toaster or other hot area which might damage the cable. · Do not place the kettle where the mains lead could fall into a sink. Location · Always locate your kettle away from the edge of the worktop. [. . . ] · Boil only as much water as you need as this saves electricity. 2 Place the kettle on the base unit, ensuring the kettle locates on to the 360° connector. · The 360° connector allows the kettle to be located at any position. - ideal for left and right handed users and convenient positioning on worktop. 3 Plug in and switch on at the wall socket. The `power on' neon, will light up. 5 When the water boils the kettle will switch off automatically. · If you are using the kettle for the first time, pour away the boiled water and refill. 6 Lift the kettle from the base unit by the handle ensuring you hold the kettle level. · To re-boil, switch to ON again. If the kettle has just switched off wait a minute or so before switching it back on again. · If you do not put in enough water, or switch on the kettle when it is empty, the safety cut-out will switch off the power automatically. If this happens, refill and wait a few minutes for the element to cool, then use as normal. Filter removal 1 Open the lid. 2 Lift the filter upwards from its location using the tab provided. 3 To refit the filter, slot it into the side wall guides and press down firmly. Ensure the filter is correctly located into the central guide. WARNING: Unless the filter is fitted correctly, the kettle lid may not close and lock securely. The auto switch off function may also be affected. 4 KT43083 Rev 1 16/4/04 3:36 PM Page 5 Descaling IMPORTANT: As this kettle is fitted with a concealed element it must be descaled regularly. The frequency of descaling depends on usage and the hardness of the water in your area. Excessive scale can cause the kettle to switch off before boiling and may damage the element invalidating the warranty. It is essential that regular descaling takes place. Remove hard scale using a proprietary descaling product suitable for plastic kettles. [. . . ] 4 Where the appliance has been used for hire purposes or non domestic use. 5 Morphy Richards are not liable to carry out any type of servicing work, under the guarantee. 6 Plastic filters for all Morphy Richards kettles and coffee makers are not covered by the guarantee. This guarantee does not confer any rights other than those expressly set out above and does not cover any claims for consequential loss or damage. [. . . ]