User manual MORPHY RICHARDS IB47505

[. . . ] · Do not lift the coffee by gripping the water reservoir. Hold the body of the coffee maker. · Disconnect the coffee maker from the mains supply when filling, cleaning or not in use. · Keep the outside of the coffee maker area clean and dry at all times. · Do not immerse the coffee maker itself in water and always ensure the electrical connections are kept dry. [. . . ] Gently tap out the coffee. Ensure the filter holder is flat against the brewing head and turn the handle towards the right as far as it will go. 12 Once the orange `warm up' light goes out your machine is ready to make the next espresso. Steam function 7 Place 1 or 2 pre-heated cups below each of the holes in the filter holder and I . When the coffee maker is at the correct temperature the orange `warm up' light will go out. Turn the selector dial to the coffee setting. You will hear the machine make a pumping noise, this is normal. I The froth attachment makes it easy to produce frothy milk for cappuccino. 1 Before using the steam nozzle, remove the filter holder. 2 Attach the froth attachment to the end of the steam nozzle . IMPORTANT: For the froth enhancing attachment to work you must ensure that it is pushed firmly onto the steam nozzle. 8 9 Once the cups are filled to the desired level turn the selector dial to the `0' off position. Water will still filter through for approximately 8 seconds after the machine has been turned off. 3 4 5 5 Fill the water reservoir with cold tap water. The red `power' light and orange `warm up' light will both illuminate. Swing the steam nozzle with the froth attachment to the side of the machine. 6 Pour cold milk into a suitable jug. Use approximately 100ml for each cappuccino. · Skimmed milk or fat reduced milk will make frothing easier. Note: For best results we recommend to use refrigerated milk and a stainless steel jug that is well chilled. When the unit is the right temperature the orange `warm up' light will go out. Hold the jug under the steam nozzle so that the head of the froth attachment is immersed in milk and turn the selector dial to the steam setting. You will hear the machine make a pumping noise, this is normal. Hot water drinks You are able to make hot water drinks such as tea or instant soups using the steam nozzle. 1 Ensure the unit is cold before removing the froth attachment from the steam nozzle if attached. Follow the `steam function' and heat up hot water instead of milk. 7 2 Note: It is normal for the orange `warm up' light to cycle on and off during the water heat up process. Preheating coffee maker To make hotter coffee and to warm your coffee cups you may preheat your machine. This can be achieved by following the `espresso operation' by passing hot water through the coffee maker but without using coffee. Cups should be placed upside down on the warming plate. Please note that this may take upto 20 minutes depending upon the type of cup used. IMPORTANT: Do not allow the tip of the nozzle to touch the bottom of the jug because this could obstruct the passage of the steam. 8 Once the froth has been produced, turn the selector dial to the `0' off position and remove the jug. Cleaning and maintenance You must clean the steam nozzle and froth attachment immediately after each use. 1 Simply wipe the steam nozzle, warming plate and exterior with a clean, damp cloth. [. . . ] Please have the following information ready to enable our staff to deal with your query quickly. · Name of the product · Model number as shown on the underside of the appliance. 7 Your two year guarantee · It is important to retain the retailers receipt as proof of purchase. Staple your receipt to this back cover for future reference. Please quote the following information if the product develops a fault. [. . . ]