User manual MORPHY RICHARDS IB70280

[. . . ] Unprofessional repairs can be dangerous for users. · Use only genuine Goblin spare parts and accessories. Location · Do not use or keep this product outside when it is raining. · Do not store the appliance near hot ovens or heating appliances. Electrical requirements Check that the voltage on the rating plate of your appliance corresponds with your house electricity supply which must be A. C. If the socket outlets in your home are not suitable for the plug supplied with this appliance, the plug should be removed and the appropriate one fitted. [. . . ] Keep it closed for full suction and open for reduced suction. recommended not to use the extension tube. fl fl 5 Emptying the dust container IMPORTANT: To obtain best results from your cleaner it is important to empty the dust container and clean the filters regularly, otherwise the airflow and suction power will be reduced. If the dust container is not full and performance deteriorates, first check if there are any blockages in the accessories or tubes. If these are clear, it is necessary to empty the dust container and clean the filter. Step 3 Holding the dust container over a dustbin, grip the tabs on the back of the filter, pull to remove and empty out the dust. Step 1 Remove the hose by pressing in the clips and pulling the hose away from the hose inlet. Step 2 Slide back the dust container release button ¤ and lift off the dust container using the folding handle. 3 CLEAN THE FILTER before replacing, see page 7. 4 Replace the clean filter, making sure that it is correctly fitted, then replace the dust container. Press down firmly until it clicks into position. IMPORTANT: Do not operate your cleaner without the filters fitted. 6 Cleaning the filter Everytime the dust container is emptied the filter should be cleaned. Pull the tabs at the side of the mesh filter cover to remove the pleated filter cover. Use the brush attached to the rear of the filter to brush the fine dust from between the filter pleats. Dust can also be removed by rigorously shaking the filter. Refit the mesh filter cover and reinstall the filter into the cleaner. The filter should also be washed regularly in warm water, but do not use detergent. Allow to dry naturally and ensure it is totally dry before replacing it. An additional filter (not filter cover or brush) is provided allowing continued use while one filter is washed and dried. When changing the filters over ensure the filter cover is fitted to the filter that is being placed in the machine. The brush can also be attached to the new filter. Note: A protection device maintains the air-flow to the motor if the filters become blocked. When this operates the sound of the cleaner will increase slightly. If this happens, clean the filter and clear any blockage, the sound of the cleaner will then return to normal. WARNING: Never use the appliance without the filters installed, otherwise damage to the product may occur which would not be covered by the guarantee. 7 Cleaning the motor protection filter The motor protection filter should be cleaned regularly by sliding out of its location and shaking rigorously to dislodge any dust. The motor protection filter can also be washed in warm water and left to air dry. IMPORTANT: Do not use detergents and ensure filter is thoroughly dry before re-inserting into the machine. Cleaning and replacing the exhaust filter The exhaust filter should be cleaned regularly by sliding out of its location. The exhaust filter is non washable and should be replaced every 6 months. [. . . ] A list containing details of your nearest service agent is included with your appliance but please contact the helpline quoting model number and serial number should you require further assistance. Repair or replacement of the product is subject to the exclusions set out below (1-5). If you suspect a fault, follow the simple checks detailed below before returning the appliance or calling the helpline. · Check the dust container and filters for blockages. [. . . ]