User manual MORPHY RICHARDS IB70531

[. . . ] In addition we offer the following safety advice. Other safety considerations · Do not use any chemical detergents, perfumes, alcohol etc in the water. · Repairs to electrical appliances are only to be undertaken by trained personnel. Unprofessional repairs can be dangerous for users. · Use only genuine Goblin spare parts and accessories. [. . . ] The cleaner is now ready for use when the orange steam ready light goes out. When the lock is pushed forward the steam trigger cannot be activated. Push the lock to the rear position to release the steam trigger. 2 When you press the steam trigger, steam will be emitted from the nozzle. Direct the steam handle at a cloth first until the steam is emitted evenly. Steam ready display 1 The steam ready light (orange) will illuminate when switched on. It will take approximately 11 minutes to reach temperature. 2 When the correct temperature has been reached the steam ready light (orange) will go out. Note: The steam ready light will go on and off during use. This is to keep the steam at the correct temperature. WARNING: To avoid injury, the cleaner should be switched off during breaks or pauses of work. For extra safety apply the trigger safety lock. If you leave the working area, please switch the cleaner off and unplug. 3 Keep the steam trigger pressed and direct the steam at the surface to be cleaned, removing the dirt by moving the steam jet backwards and forwards over the area. 4 To stop the steam jet, release the steam trigger. WARNING: Do not hold the steam jet concentrated in one place for too long. · To control the steam temperature and the cleaning power move the handle closer to or further away from the surface. 6 70530 Rev 4 2/6/04 2:53 PM Page 7 Attaching tubes & handle WARNING: Unplug the unit and allow to cool before fitting or changing attachments as they become hot during use. Attach the desired accessory to the hose handle, extension tubes can be attached to the handle for extra reach. 1 Push the extension tubes onto the connection nozzle as far as it will go until you hear a click. 1 Fit the elbow attachment to the floor nozzle and twist 1/2 a turn. 2 Fit the floor nozzle to the extension tube or handle. Some tasks may be easier with only one, tube fitted or non at all. 2 To connect the desired accessory directly to the steam handle, slide the handle into the accessory head or tube until it locks in place. 3 To fit the cloth to the floor nozzle pull the cloth under the clips on both sides. Extra cloths can be ordered by using our helpline. Alternatively any strong, uncoloured cotton cloths may be used. Floor nozzle The floor nozzle is used for the cleaning of large, washable wall and floor areas. The floor nozzle can be used with or without the cloth cover. · Sensitive surfaces, wood, linoleum etc. [. . . ] Subject to the exclusions set out below (1-5) the faulty appliance will then be repaired or replaced and dispatched usually within 7 working days of receipt. If you suspect a fault, follow the simple checks detailed below before returning the appliance or calling the helpline. · Check the plug and socket and check if the lights are illuminated. · Check the attachments for blockages. [. . . ]