User manual MORPHY RICHARDS IB71061

[. . . ] If the socket outlets in your home are not suitable for the plug supplied with this appliance the plug should be removed and the appropriate one fitted. If you cut off the plug and let go of the cable it will rewind into the machine therefore you must pull out a length of cable and secure it before cutting the plug off and re-fitting a new one. WARNING: The plug removed from the mains lead, if severed, must be destroyed as a plug with a bared flexible cord is hazardous if engaged into a live socket outlet. Should the fuse in the 13 amp plug require changing a 13 amp BS1362 fuse must be fitted. · · Location · Do not use or keep this product outside in the rain. [. . . ] (Shown on page 3) Pull out the mains cable to it's full length and plug into the mains supply. Switch on by pressing the on/off switch fi. Automatic cable rewind After use, unplug and press the cable rewind switch to retract the cable. WARNING: When using the cable rewind, always hold the plug as the cable will rewind quickly. 2 3 Variable power A Variable power switch fl varies the suction power as required. For example, maximum suction can be used for cleaning carpets, hard floors etc. and reduced suction for cleaning upholstery and curtains. Suction can also be controlled using the airflow regulator on the hose www. morphyrichards. com 5 71060 Rev5 17/5/06 12:52 Page 6 DUST CANISTER Emptying To obtain the best results from your cleaner empty the dust canister regularly, otherwise the airflow and cleaning power will be reduced. 1 Remove the dust canister from the product by pressing the dust canister release button < Lift up the lid and remove the canister from the product, pulling the dust canister away from the product. C Everytime the dust canister is emptied, turn the yellow dial (a minimum of 5 revolutions) prior to pressing the dust canister release button (this will agitate the fine dust between the filter pleats and restore the air flow) Holding the dust canister over a dustbin press the dust release button as shown D, the bottom of the dust container will drop down to release the dirt. Close the bottom of the dust canister by pressing the base upwards until it clicks into place. · 5 Refit the dust canister back into the product. Make certain the dust canister feet are located in place. · 1 FILTERS Cleaning canister filter To access filter assembly rotate the canister lid anti-clockwise and lift off lid E. Use the filter cleaning brush to remove any fluff from the outside of the mesh filter or gently tap. Rotate mesh filter anti-clockwise to disassemble. Shake the pleated filter to remove an dust. Both the mesh and pleated filters may be washed (in cool water only) but must be thoroughly air dried before refitting. Locate in the canister and replace the lid, twisting to lock into place. C 2 3 D 2 4 5 3 4 IMPORTANT: Do not use detergents to clean the filter. The filter should be regularly washed, and must be thoroughly dry before the machine is used. The dust container may not lock back onto the machine unless the filter is fitted correctly 6 ALLERGY SUFFERERS If the allergy sufferer is emptying the product it is recommended that the container is placed into a plastic bag to empty. 1 Place the container inside the plastic bag, releasing the container with one hand whilst holding the top of the bag closed with the other, leave the dust to settle for a few seconds before carefully removing the empty canister. The plastic bag can then be sealed and disposed of. Vacuum freshener (certain models only) 1 After emptying the dust canister and removing the filters (as described in points 1-4 above) open the clear packaging and remove the vacuum freshener. F 2 Place it directly into the dust canister as shown. F Refit the filters and canister (as described in point 5 above). [. . . ] Subject to the exclusions set out below (see Exclusions) the faulty appliance will then be repaired or replaced and dispatched usually within 7 working days of receipt. 2 If you suspect a fault, follow the simple checks detailed below before retrying the appliance or calling the helpline. 1 · Exclusions Morphy Richards shall not be liable to replace or repair the goods under the terms of the guarantee where: The fault has been caused or is attributable to accidental use, misuse, negligent use or used contrary to the manufacturers recommendations or where the fault has been caused by power surges or damage caused in transit. The appliance has been used on a voltage supply other than that stamped on the products. [. . . ]