User manual MORPHY RICHARDS IB73307

[. . . ] Repairs to electrical appliances are only to be undertaken by trained personnel. Unprofessional repairs can be dangerous for users. Use only genuine Morphy Richards spare parts and accessories Never over-extend the hose such that the cleaner is pulled over. If the cleaner is knocked over, switch off before attempting to upright. [. . . ] · If additional length is required, attach one or both extension tubes between the hose and tool. IMPORTANT: Never over extend the hose such that the cleaner is pulled over. Dust bag condition To obtain best results from your cleaner the dustbag needs to be emptied when necessary, otherwise the airflow and cleaning power will be reduced. When the dustbag indicator shows red continuously and performance deteriorates, first check if there are any blockages in the accessories or tubes. If these are clear, it is necessary to empty the dustbag. If it is still showing red after emptying the dust bag and cleaning the filters, check to see if the hose is blocked. 3 Remove the dust bag by holding the tab and pull towards you. Remove carefully to avoid dust/dirt spilling from dust bag. 4 Hold the dustbag over a dustbin and slide the clip from the bottom of the bag and tip the contents of the bag carefully into the bin. Shake the bag vigorously to remove excess dust. 5 Slide the clip back onto the bottom of the dustbag and replace the dustbag. Push the dustbag fully back into position. Note: the front panel will not close unless the dustbag is correctly fitted. 6 Once the dust bag is in place, replace the front panel by aligning the bottom locking tabs with the slots in the body, close cover slowly allowing the front panel to snap in place. IMPORTANT: To maintain performance we recommend that the reusable bag is hand washed regularly in warm water. Do not use detergents as these could affect performance. Allow to dry naturally as direct heat may effect the material. A spare bag is provided for use while washing the other bag. IMPORTANT: Ensure the dustbag is totally dry before refitting it into the cleaner. Emptying the cloth dust bag FG 1 Unplug power cable from wall socket. 2 Remove the front by pressing the cover release lever at the top. G F Î 5 8407 Upright EcoVac ib 4 03/12/2002 1:34 PM Page 6 Changing the filters H Changing the brush belt If the power brush stops rotating it is likely that the drive belt has snapped (usually because the brush has been stalled). Replacement belts can be obtained from Morphy Richards or a Service Agent. 1 Disconnect the cleaner from the mains supply. 2 Place the cleaner face down in the flat position. 3 Use a cross-head screwdriver to remove the two screws from the front bottom and the central screw under the height adjustment mechanism I. [. . . ] These numbers can be found on the base of the product. Serial no. to indicate the date of initial purchase. To qualify for the two-year guarantee the appliance must have been used according to the manufacturers instructions. For example bags and filters shall have been regularly cleaned or replaced. Morphy Richards shall not be liable to replace or repair the goods under the terms of the Guarantee where: 1 The fault has been caused or is attributable to accidental use, mis-use, negligent use or used contrary to the manufacturers recommendations or where the fault has been caused by power surges or damage caused in transit. [. . . ]