User manual MORPHY RICHARDS IB73360

[. . . ] If the cleaner is knocked over, switch off before attempting to upright. Never pick the cleaner up by the floor nozzle when connected to the mains, use the carrying handle. WARNING: Keep loose clothing, hair, fingers etc. away from the floor nozzle whenever the cleaner is connected to the mains. [. . . ] 5 Remove the hose connector Í from the rear of the cleaner. Lift the hose · from the top handle hook. Insert the hose clip ~ into the hose clip slot Ë. · Push the required attachment firmly onto the end of the hose. · If additional length is required, attach one or both extension tubes. · IMPORTANT: Always fix the hose clip ~ to the main body slot Ë when using the hose D min max 4 VC73360MUK-CyclonicBaglessRev3 3/11/05 4:41 pm Page 5 and tools. · Never over extend the hose such that the cleaner is pulled over. IMPORTANT: Turning the cleaner sideways helps prevent the cleaner being pulled along by the stretch hose. Emptying Empty the dust canister regularly even if it does not look full this will maintain the performance. 1 Remove the front cover by lifting the cover release lever ¤ E. 2 Lift-up the dust canister release Î and pull the canister away from the main body. 4 Turn the lid 1/4 turn anti-clockwise to unlock, lift off the lid with pleated filter, Ì put to one side. F 5 Lift out the central mesh filter Ô from the dust canister Ó G. 8 Shake the pleated filter to remove all dust. 9 Re-fit pleated filter with lid into the dust canister by lining up the two arrows and turning the lid 1/4 turn clockwise to lock. Using & cleaning turbo nozzle (Certain models only) Attach the turbo nozzle to the hose end connector Í for use on upholstery and stairs. After use your turbo nozzle may become clogged. Turn over the nozzle and pull away any hairs or fibres. If they are tightly wound around the brush carefully snip the fibres with scissors, being careful not to damage the brush bar, pull away from the brush bar and dispose. Î ¤ E < F G Ì Ï Ô Ó 5 VC73360MUK-CyclonicBaglessRev3 3/11/05 4:41 pm Page 6 10 Re-fit dust canister into cleaner and push to lock into position. Then re-fit front cover. Safety cut-out If the cleaner overheats a motor protection thermostat will automatically switch the motor off. If this happens, switch the cleaner off, unplug from the power supply and leave the cleaner to cool for at least 30 minutes. Check the airways for blockages, empty dust canister and clean the filters before restarting. underneath the dust canister 1 Remove the dust canister. 2 Lift out the filter and shake over a dustbin. The filter may also be washed in water (no detergents) but must be totally dry before refitting. [. . . ] 3 Repairs have been attempted by persons other than our service staff (or authorised dealer). 4 Where the appliance has been used for hire purposes or non-domestic use. 5 Morphy Richards are not liable to carry out any type of servicing work, under the guarantee. 6 Consumables such as the filters and belt are not covered by the guarantee. [. . . ]