User manual MORPHY RICHARDS LCD 47076

[. . . ] 47076 Rev1 29/4/08 11:28 Page 1 12 cup filter coffee maker Please read and keep these instructions Getting the best from your new coffee maker. Safety first Caution must be used when handling hot water, coffee or steam. Run water through your machine before first use It is important to run water through your coffee maker in order to rinse the machine. You can also run water through to warm your coffee machine. [. . . ] The red power light will glow and the coffee will start to brew. Hot water will start to flow through the coffee grounds and into the glass jug as coffee. When the coffee has been made, serve as required. The anti-drip valve will prevent any remaining coffee dripping onto the hot plate. Ensure that the jug is replaced on the hot plate after serving. While the coffee maker is switched ON, the hot plate will keep the coffee warm. a 7 8 9 General use 1 2 Lift up the hinged reservoir lid ⁄. Fill the water reservoir with the required amount of water using the water level indicator ¤ as a guide A. Both the jug ‹ and the water level indicator are marked in cups. Do not exceed the maximum level on the water gauge. Spoon the required amount of ground filter coffee into the mesh filter ‚, spreading it evenly. We suggest one rounded dessert spoon for every cup, but individual tastes will vary. Ensure the filter is sitting properly in the filter holder and do not fill above the mesh line. Slide the jug into the coffee maker ensuring it sits correctly on the hot plate fi. The jug lid must be in place during the brewing process, otherwise the non-drip valve ‡ will not open, causing the filter to flood. €¢ 10 Switch off the coffee maker when the jug is empty or the coffee is no longer required. WARNING: The coffee maker and hot plate are hot and remain hot for some time after switching off. 12 Remove the permanent filter and empty the used coffee grounds. Wash the filter immediately and dry thoroughly. 3 4 5 Refilling Switch off the coffee maker and allow 3 minutes to cool before refilling with cold water. 5 47076 Rev1 29/4/08 11:28 Page 6 BUTTONS KEY ON/OFF Auto timer Warmer CONTROL PANEL • Adjustable warming plate temperature This coffee maker gives you the option of adjusting the Stay Warm Setting to slightly reduce the temperature of the coffee after it has brewed. When brewing the coffee, a steady orange light will appear on the ‘warmer’ button. [. . . ] We recommend you use a proprietary liquid descaler which is especially made for coffee makers and plastic kettles. Follow the instructions on the bottle or sachet, and then operate the coffee maker with just water 3 times before making coffee. Do not use a kettle descaler unless the packet specifically states it is suitable for coffee makers. Note: The permanent mesh filter should not be used during descaling. [. . . ]