User manual MORPHY RICHARDS ORB VACUUM CLEANER

[. . . ] If the socket outlets in your home are not suitable for the plug supplied with this appliance, the plug should be removed and the appropriate one fitted. If you cut off the plug and let go of the cable it will rewind into the machine. Therefore you must pull out a length of cable and secure it before cutting off the plug and refitting a new one. WARNING: The plug removed from the mains lead, if severed, must be destroyed as a plug with bared flexible cord is hazardous if engaged into a live socket outlet. [. . . ] and reduced suction for cleaning upholstery and curtains. Suction can also be controlled using the airflow control on the handle È. Closed for maximum suction, open for reduced suction. Automatic cable rewind After use, unplug and press the cable rewind button > to retract the cable. WARNING: When using the cable rewind, always hold the plug as the cable will rewind quickly. B Á C Ê Dust disposal To obtain the best results from your cleaner empty the dust container regularly, otherwise the airflow and cleaning power will be reduced. 1 With the hose removed, lift out the dust container using the handle D. 2 Holding the dust container over a dustbin, pull out the filter , , to empty out the dust E. 3 Replace the filter and replace the dust container. IMPORTANT: Do not operate your cleaner without the dust container fitted. Cleaning the filter Everytime the dust container is emptied, the filter should be cleaned. Lift the tab at the bottom of the filter to remove the cover F. Use the brush attached to the rear of the filter to brush the fine dust from between the the filter folds. Refit the front cover and re-install the filter into the cleaner. The filter should also be washed regularly in warm water, but do not use detergent. Allow to dry naturally and ensure it is totally dry before replacing it. A spare filter is provided. D E , , F Cleaning the motor protection filter The micro-filters must be cleaned everytime the dust container is emptied to remove the fine dust particles collected. The motor protection filter is in the dust container compartment. With the dust container removed, lift out the filter holder, remove the filter and shake to clean G. Storage position When finished, you can store accessories by locating the tube storage clip into the slot on the underside of the cleaner as shown I. I Cleaning the Hepa exhaust filter The Hepa exhaust filter · is located at the back of the cleaner. To remove, press down the catch and pull the cover away to remove the filter H. Use the brush supplied to gently remove dust from the pleats. Wash reguarly in warm water, but do not use detergent. Allow to dry naturally and ensure it is totally dry before replacing it. IMPORTANT: Do not operate without filters fitted. G H · Care and maintenance Your cleaner is manufactured to withstand normal day-to-day use, but an occasional wipe over with a damp cloth will help maintain its good looks. Abrasive cleaners should not be used. Your two-year guarantee It is important to retain the retailers receipt as proof of purchase. [. . . ] For example filters must be cleaned and replaced regularly. Morphy richards shall not be liable to replace or repair the goods under the terms of the Guarantee where: 1 2 3 4 5 The fault has been caused or is attributable to accidental use, mis-use, negligent use or used contrary to the manufacturers recommendations or where the fault has been caused by power surges or damage caused in transit. The appliance has been used on a voltage supply other than that marked on the products. Repairs have been attempted by persons other than our service staff (or authorised dealer). Where the appliance has been used for hire purposes or non-domestic use. [. . . ]