User manual MORPHY RICHARDS RN40310MUK REV 3

[. . . ] Never allow the mains lead to over hang the work surface. The socket should always be off before plugging or unplugging from the socket. Never yank the cord to disconnect from the socket, instead, grasp the plug and pull to disconnect. Do not allow the cord to touch hot surfaces. [. . . ] If they don't, you should follow the fabric guide on page 3, but be sure to test the temperature by ironing the hem of the garment or similar area first. If you turn the control dial down from a hot setting to a cooler setting, wait until the iron temperature has stabilised before you continue ironing. 4 UK Helpline 0844 871 0953 Replacement Parts 0844 873 0719 Ireland Helpline 1800 409 119 RN40310MUK Rev3:RN40310MUK Rev3 20/11/2009 16:01 Page 5 FILLING A 1 Make sure that the iron is not plugged in and then set the steam control / to the ` ' position before filling the iron with water. Lift up the fill cap and fill with water through the filling hole > using the beaker provided A. IN HARD WATER AREAS, THE USE OF DISTILLED OR DEMINERALISED WATER IS RECOMMENDED. Never use battery topping up fluid or water containing any substances like starch or sugar, or defrosted water from a refrigerator. 3 Always pour out the remaining water after use. WARNING: When filling your iron with tap water, always use the beaker provided. Never fill directly under the tap. FEATURES OF YOUR IRON Temperature indicator light The indicator light shows that the iron is warming up. When the required temperature is reached, the light will go out and will cycle on-off during operation. A 2 Dry ironing You can use your iron as a dry iron only. Make sure the steam control / is set to the ` ' symbol. Any temperature setting may be used, depending on the garment. The spray feature may be used provided there is water in the tank (see filling section). You do not need to put any water in the tank when dry ironing only. B Spray C Press the spray button ¤ and aim the spray of water at stubborn creases. You can do this whilst dry ironing providing there is water in the tank. When using the water spray, it may be necessary to push the button a few times to get the spray pump primed. TEMPERATURE CONTROL Plug in the iron and switch on. Set the temperature control dial to the temperature required B, but don't start ironing immediately. If you wait a few minutes, the iron will stabilise at the required setting. Your Morphy Richards iron is fitted with an indicator light , which will go on and off while you are ironing. This is perfectly normal as it shows that the iron is maintaining the heat setting you have chosen. It is always a good idea to begin with cool fabrics and work up to higher settings. An iron heats up quicker than it cools down, so you'll save time and electricity. C Variable steam Fill the iron with water as described in `Filling', then insert the plug into the electrical socket. The steam output can be switched from off to on by sliding the steam control / D. [. . . ] Please quote the following information if the product develops a fault. These numbers can be found on the base of the product. All Morphy Richards products are individually tested before leaving the factory. In the unlikely event of any appliance proving to be faulty within 28 days of purchase, it should be returned to the place of purchase for it to be replaced. EXCLUSIONS Morphy Richards shall not be liable to replace or repair the goods under the terms of the guarantee where: 1 The fault has been caused or is attributable to accidental use, misuse, negligent use or used contrary to the manufacturer's recommendations or where the fault has been caused by power surges or damage caused in transit. [. . . ]