User manual MORPHY RICHARDS SEMI-ELECTRONIC 40715

[. . . ] Steam/spray shot Please read and keep these instructions Safety first Caution must be used when handling this appliance as it does get very hot. Always switch off the unit and allow to cool before cleaning or storing. Jet cleaning (Certain models) Your iron will give the best ironing results and will last longer if you apply jet cleaning after each period of ironing. Self cleaning (Certain models) Your iron will give the best ironing results and will last longer if you clean the soleplate once a month. [. . . ] make sure the variable steam control / is set to the `0' symbol. Any temperature setting may be used depending on the garment. The spray feature may be used provided there is water in the tank (see filling section). You do not need to put any water in the tank when dry ironing only. Do not use shot of steam at temperatures below the steam range shown on the control dial. Note: For optimum steam quality, do not operate the shot more than three times in succession. Hold the iron in a vertical position between 1cm and 2cm away from the item F. Press the shot of steam button ¤, this will create vertical steam. This feature is especially useful for removing creases from hanging clothes, curtains, wall hangings, etc. Note; For optimum steam quality, do not operate the shot more than three times in succession. You can do this whilst dry ironing providing there is water in the tank. When using the water spray it may be necessary to push the button a few times to get the spray pump primed. Your iron is fitted with a no drip system which is designed to prevent water escaping from the soleplate when the iron is too cold. During use, the no drip system may emit a loud click, particularly during heat-up or whilst cooling down. This is perfectly normal and indicates that the system is functioning correctly. Fill the iron with water as described in `Filling', page 4 and insert the plug into the electrical socket. The steam output can be varied from low to high by turning the variable steam control D. When using the iron at the bottom of the steam range, the steam output should be adjusted to the low setting. The steam facility should only be used on garments which are suitable for ironing at 2, 3 dot and MAX setting. Your iron is fitted with the auto shutoff function it will automatically shut down after a set period. the `safety switch off' led will flash on the function panel. If the iron is left unattended in the horizontal position it will shut down after 30 seconds on certain models and after 1 minute on models with illuminated tanks. [. . . ] If the fault develops after 28 days and within 24 months of original purchase, you should contact the Helpline number quoting Model number and Serial number on the product, or write to Morphy Richards at the address shown. You may be asked to return a copy of proof of purchase. Subject to the exclusions set out below (see Exclusions) the faulty appliance will then be repaired or replaced and dispatched usually within 7 working days of receipt. If for any reason this item is replaced during the 2 year guarantee period, the guarantee on the new item will be calculated from original purchase date. [. . . ]