User manual MORPHY RICHARDS STORM PETS CYLINDER VACUUM CLEANER REV 3

[. . . ] Always disconnect the appliance from the main supply after use or prior to emptying or cleaning. To protect against fire, electric shock and personal injury do not immerse cord, plug or cleaner in water or other liquid. ELECTRICAL REQUIREMENTS Check that the voltage on the rating plate of your appliance corresponds with your house electricity supply which must be A. C. If the socket outlets in your home are not suitable for the plug supplied with this appliance the plug should be removed and the appropriate one fitted. If you cut off the plug and let go of the cable it will rewind into the machine, therefore you must pull out a length of cable and secure it before cutting the plug off and re-fitting a new one. [. . . ] B C Switching on C Always pull out the supply cable to its maximum length. Plug the appliance into the mains supply. Ensure that the variable power 4 UK Helpline 0870 060 2604 Replacement Parts 0870 167 6635 409119 Ireland Helpline 1800 70313 rev3 3/7/06 13:59 Page 5 D Controlling suction power The suction power can be varied to suit the surface being cleaned, by using the variable power control fi. See table for guideline settings. E Open Close The suction power can also be adjusted using the fingertip control on the handle E. Closed: Open: Power setting AX M full suction reduced suction Application MI N Curtains and delicate fabrics Recommended settings Alter the power setting to suit surface. AX M MI N Textiles and upholstery AX M MI N Floor coverings such as rugs economy setting for carpets AX M MI N Carpets or hard floor coverings www. morphyrichards. com 5 70313 rev3 3/7/06 13:59 Page 6 Tube standby F During short breaks in cleaning the tubes can be held in an upright, `standby' position , whilst you move furniture for instance. IMPORTANT: Ensure that the appliance is never left unattended whilst it is switched on. 4 5 6 Dispose of the bag with your household waste. Replace the dust bag holder and close the cover. F Switching off G Switch off the appliance. Remove the plug from the mains supply and rewind the power cable using the cable rewind switch fl. WARNING: When using the cable rewind, always hold the plug as the cable will rewind quickly. 1 IMPORTANT: The dust bag G compartment cover can only be closed once a dust bag has been correctly fitted. Vacuum fresheners L Vacuum fresheners can be used H to banish pet odours from your vacuum and carpets. After removing the dustbag (as described in points1-4 above) open the clear packaging and remove the vacuum freshener. Place it directly into the new dust bag. Insert the new dustbag (as described in points 5 & 6 above). Only place the vacuum freshener directly into the dust bag Do not place in the filter or J any other part of your vacuum cleaner. New vacuum fresheners can be ordered by calling Morphy Richards Replacement parts. STORAGE Tube park H The vacuum cleaner can be stored in an upright position. Rotate the floor nozzle until the lug on the back of it can be fitted into the tube park slot on the base of the appliance ·. 2 3 I DUSTBAG Changing the dustbag If suction power is reduced or if the `dust bag full' indicator < is permanently fully red, the dust bag needs changing. Also check whether the suction hose, tube or nozzle are blocked. To access the dust bag, press the dust compartment release lever , , to open the cover I. 1 Pull the tab on the dust bag to one side so that the opening is hygienically sealed. Pull out the dust bag holder and dust bag in an upward direction J. Pull the bag sideways out of the holder K. 1 FILTERS Changing/cleaning the motor protection filter The motor protection is accessible from the dust compartment only when the dust bag has been removed first. K L 2 IMPORTANT: Never use the appliance without the motor M protection filter installed, otherwise damage to the motor may occur which would not be covered by the guarantee. M 6 3 6 UK Helpline 0870 060 260 Replacement Parts 0870 167 6635 Ireland Helpline 1800 409119 70313 rev3 3/7/06 13:59 Page 7 2 3 4 Open the flap on the filter holder. [. . . ] Please quote the following information if the product develops a fault. These numbers can be found on the base of the product. · · · retrying the appliance or calling the helpline. Check the plug is firmly in the socket is working by trying another appliance. [. . . ]