User manual MOTOROLA C341

[. . . ] MORE HERE > Welcome This reference guide is a companion to the user guide that is packaged with the Motorola C341a Series CDMA wireless phone. Refer to the user guide general information about using the phone. This reference guide contains information about topics and features that are not covered in detail in the user guide. This reference guide is not a replacement for the user guide that you received with your wireless phone. Your user guide contains important safety information on the use of your wireless phone that is not included in this reference guide. [. . . ] This accessory provides an alternative way for you to use your phone without using your handset. Note: The use of wireless devices and their accessories may be prohibited or restricted in certain areas. Always obey the laws and regulations on the use of these products. > Other Settings > Car Settings > Power-Off Delay > time delay Setting Charger Time When your phone is connected to a car kit, you can set it to charge itself for a specified time period after you switch off the ignition. This helps ensure that the phone battery gets fully charged while the vehicle is parked. Note: This feature may not work with all car ignition switches. Find the Feature M > Settings Activating a Connected Speakerphone To use an external speakerphone with your phone, connect the speakerphone and, during an active call: Press SPEAKER (+) (if available) or M > Spkrphone On To activate the connected speakerphone > Other Settings > Car Settings > Charger Time > charge time Getting More Out of Your Phone Exchanging Data with a PC Motorola's mobile PhoneTools® software lets you transfer data between your phone and a computer. You can: · use your phone as a modem to connect to the Internet · send and receive both email and SMS text messages · synchronize your Phonebook and Datebook Setting Automatic Answer You can set your phone to automatically answer calls after 2 rings (4 seconds) when connected to the Easy-Install Hands-Free Kit or a phone headset. Find the Feature M > Settings > Other Settings > Car Settings or Headset > Auto Answer Installing the Software Install the software from the mobile PhoneTools® CD-ROM. See the mobile PhoneTools user's guide for more information. Note: This software is required to transfer data between your phone and an external device. Setting Automatic Handsfree You can set up your phone to automatically route calls to the Easy-Install Hands-Free Kit when it detects a connection. Find the Feature M > Settings Connecting the Cable Important: Make sure to install the mobile PhoneTools software before connecting your phone to a computer. Attach a Motorola OriginalTM USB cable to the phone and computer as follows. Action 1 Plug the end of the cable that matches your phone's accessory port into the phone. 2 Plug the other end--the USB connection--into the USB port on the computer. > Other Settings > Car Settings > Auto Handsfree > On or Off Setting Power-Off Delay When your phone is connected to a car kit, you can set it to stay on for a period of time after you switch off the ignition. This prevents the phone from draining your vehicle battery, but leaves the phone on long enough that you do not have to re-enter your unlock code when making short stops. Note: This feature may not work with all car ignition switches. 15 Making a Data Call Use this feature to access the Internet, using your phone as a modem. Connect your phone and do the following: Action To 1 Check the phone make sure that the phone is connected and powered on 2 Open mobile place the call through the PhoneTools® on application (such as your computer dial-up-networking) Note: You cannot dial data numbers through your phone's keypad. You must dial them through your computer. close the call and connection when the transfer is complete If you cannot end the transfer on your computer, end the call on your phone. When set to manual, you must select the Update Service feature to initiate a service update (if available). Find the Feature M > Settings > Other Settings > Network > Srvc Status > Automatic or Manual Setting Service Tones You can set your phone to beep each time the network registration status changes. Find the Feature M > Settings > Other Settings > Network > Service Tone > On or Off Getting More Out of Your Phone 3 End the transfer on your computer Setting Call Drop Alert You can set your phone to emit an alert tone whenever the network drops a call. Because digital networks are so quiet, the call drop alert may be your only indication that a call has been dropped. [. . . ] Some wireless networks may not support data transmission. If you are roaming on an unfamiliar network, this may be the case. Also, remember that data transmission usually requires a subscription. Call your service provider for more information. [. . . ]