User manual MOTOROLA H12 QUICK GUIDE

[. . . ] This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Take a moment before you get started to familiarize yourself with your new H12 Bluetooth® Hands-free Headset. Power switch Call button Indicator light Microphone Charging contacts Volume buttons Speaker Along with your headset, a charger case and a desktop charger are provided for both charging and storage. [. . . ] It may take up to 1 minute for the indicator light to turn on. Under normal use, the expected life of the rechargeable battery is approximately 400 charges. The charging case, desktop stand, and shirt clip are designed to store your headset. When not using your headset, use one of the accessories for storing convenience: · The charging case is designed for portability and protection when headset is not in use. Case can be placed in a pocket or bag and can easily fit into many car cup holders. The desktop charger displays your headset for easy access at home or the office. Turning headset on and off The indicator light first flashes blue for several seconds, then: · Flashes blue (if paired and connected to with another device becomes steadily blue (if ready to be paired) To turn your headset off, slide the Power switch off. While turned on and not on a call, you can check the headset's battery charge level by pressing and holding both Volume buttons. The indicator light displays charge status until you release the buttons. see "Indicator Lights" section for details. Note: This feature does not work when headset is in pairing mode. Your phone's Bluetooth feature is off by default. To use your headset, you must turn on the Bluetooth feature in your phone. Before you can use your headset, you must pair it with your phone. Ensure headset is in pairing mode Remove headset from charging base or desktop charger and power it on. The indicator light flashes to initiate easy pairing. After a few moments, the indicator light will be steadily lit in blue to indicate headset is in pairing mode. If the headset does not enter into pairing mode, see "Troubleshooting" section. Set your phone to look for your headset · perform a device discovery from the phone. For details about device discovery, consult your phone's user's guide. [. . . ] Note: you can disable the indicator light as follows: · Turn headset off · Press and hold both volume buttons AND simultaneously turn headset back on Audio tone Ring tone Single high tone High to low tone Single high tone when pressing volume button Ascending tone Low tone repeated very 15 seconds Descending tone Low to high tone No audio indications: deteriorating quality 2 tones repeated every 30 seconds Headset status Incoming call Phone network not available End call Volume at maximum or minimum Mute enabled Mute reminder Mute disabled Pairing confirmation/voice activation Out of range Low battery My headset will not enter pairing mode Make sure that any devices previously paired with the headset are turned off. If the indicator light is not steadily lit in blue, turn off both the other device and headset, wait 10 seconds, then turn headset back on. Wait for the indicator light to become steadily lit in blue, indicating the headset is now in pairing mode. My phone doesn't find my headset Make sure the indicator light on your headset is on (lit in blue) and steady when your phone is searching for devices. [. . . ]