User manual MOTOROLA QG-H3

[. . . ] Make sure your phone is on and the Bluetooth feature is turned on in your phone (see step 3). If the Bluetooth feature has been turned off or was turned on only temporarily, you may need to restart the Bluetooth feature (see step 3). If you have confirmed the Bluetooth feature is on in your phone, pair your phone and headset again (see step 3). [. . . ] Consumer Advocacy Office 1307 East Algonquin Road Schaumburg, IL 60196 www. hellomoto. com 1-877-MOTOBLU 1-888-390-6456 (TTY/TDD United States for hearing impaired) Guide Number: 6809498A97-O 3 TURN ON BLUETOOTH ON YOUR PHONE AND PAIR WITH HEADSET TURN ON BLUETOOTH ON YOUR PHONE AND PAIR WITH HEADSET Continued 4 TEST AND USE USING YOUR H3 See Features and Functions Guide on the reverse side of this guide for information on using your H3. Your phone's Bluetooth feature is off by default. To use your headset, turn on the Bluetooth feature in your phone. To turn on Bluetooth: (Menu) 1 Select M( > Settings > Connection > 7 Select [Look for Devices]. Note: Do not select STOP--you will automatically be taken to the next screen. Your phone and headset are now paired and ready to make and receive calls. To confirm they are operating properly, make a call: 1 Place the headset over your ear. See Bluetooth Link > Setup. 8 Select Motorola H3. 10 Enter the passkey 0000 and select OK. When your headset and phone are successfully paired, the blue light on your headset will change from steadily lit to flashing. Note: This procedure is for most Motorola phones. For other phones, see your phone's user's guide or visit www. hellomoto. com/bluetoothsupport and click Set Up My New Product. "Wearing the Headset" on the reverse side of this guide. to call and press the Send key. 2 Scroll to Power. 3 Press Change. MOTOROLA and the Stylized M Logo are registered in the US Patent & Trademark Office. The use of wireless devices and their accessories may be prohibited or restricted in certain areas. Always obey the laws and regulations on the use of these products. The Bluetooth trademarks are owned by their proprietor and used by Motorola, Inc. All other product or service names are the property of their respective owners. 2005. 2 On your phone, dial the number you want 3 If your phone and headset are successfully 4 Select On. 6 Select Handsfree. paired, you will hear ringing on the headset. After you have successfully paired your phone and headset, you do not need to repeat these initial setup steps each time you use the headset. Features and Functions Guide H3 Bluetooth® Handsfree Headset TURNING HEADSET ON/OFF To turn your headset on, press and hold the Call button until the indicator light flashes. To turn your headset off, press and hold the Call button until the indicator light flashes rapidly and then turns off. WEARING THE HEADSET 1 Open the earhook. [. . . ] With the Charger Plugged In Headset Indicator Headset Status On (steady) Charging Off Charging complete With No Charger Plugged In Headset Indicator Off On (steady) 10 rapid flashes Slow pulse Quick flash Headset Status Power off Pairing mode Pairing successful Connected (on a call) Standby (not on call) The audio tones provide information about your headset status. Audio Tone Single high tone when pressing volume button Five rapid high tones repeated every 60 sec. No audio indications; deteriorating quality Ring tone Single high tone Single low tone Dual high/low tone Single high tone Low to high tone Two ascending tones Two descending tones Headset Status Volume at minimum or maximum Low battery Out of range Incoming call Pairing confirmation Voice activation Voice tag not recognized End call Phone network not available Mute enabled Mute disabled AUDIO TONES Note: Your H3 supports both Handsfree and Headset Profiles. [. . . ]