User manual MOTOROLA T5820

[. . . ] @6864110R06@ 6864110R06-O Models T5800 and T5820 Introduction Congratulations on your purchase of a Motorola Product!Product registration is an important step toward enjoying your new Motorola Product. Registering helps us facilitate warranty service, and permits us to contact you should your Motorola Product require an update of other service. Registration is not required for warranty coverage. [. . . ] To set another channel and code combination, repeat these steps. Volume Rotate P while holding down J (T5820) or Q (T5800) until you reach a comfortable listening level. Rotate P clockwise to increase and counterclockwise to decrease volume. Monitor Button Pressing and holding J (T5820) or Q(T5800), lets you hear the radio's volume level when you are not receiving so you can adjust the volume. It is also used to check activity on current Channel before transmitting. Time-out Timer The Time-out Timer feature helps extend battery life by preventing accidental transmission. The radio will emit a continuous warning tone after M is pressed for 60 continuous seconds and will stop transmitting. Keypad Lock To avoid accidentally changing radio operation, press \ for 3 seconds. This sequence locks the menu, [ and ], and Scan (T5820 Only) functions. Once locked, you will be able to turn the radio Off and On, increase or decrease volume, transmit, send a call tone and monitor. To unlock, press and hold \ for 3 seconds. Talking and Listening 17 Scan (T5820 Only) By Scanning, you can monitor Channels and Codes for transmissions and lock in on the one that interests you. More importantly, you can find someone in your group who has accidentally changed Channels and is talking during your scan. Talking and Listening To start scanning, briefly press and release the J. If you activate scan while your code is set to 0, then the radio will check for activity on each Channel regardless of the Code in use on that Channel. If you activate scan while the Code is set on 1 to 38, the radio will check for activity on each Channel, but only for Codes 1 to 38. When the radio detects Channel activity, it stops on that Channel and displays the Code in use. While the radio is scanning, h will display and scroll through the Channels. When activity is detected on a Channel, the radio will stop scanning and you will hear whatever transmissions are detected. The radio's display will show the Channel and Code on which activity was detected. If you want to respond to the transmission, press the M button within 5 seconds and you can respond. To stop scanning, briefly press and release the J. Scan Advance If scan stops on a Channel that you don't want to listen to, briefly press either the [ and ] to resume scanning for the next active Channel. 18 Nuisance Delete If scan continuously stops on an undesired Channel: · Press and hold either [ or ] for at least 3 seconds. These steps will temporarily remove the undesired Channel from being scanned. [. . . ] The depreciation will be an equal amount per year over the lifetime of the Products, as established by Motorola. Motorola will have no liability to you with respect to any claim of patent infringement that is based upon the combination of the Products or parts furnished under this limited warranty with ancillary equipment, as defined in VI. , above. This is Motorola's entire liability with respect to infringement of patents by the Products. State Law and Other Jurisdiction Rights Some states and other jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, or limitation on the length of an implied warranty, so the above limitations or exclusions may not apply to you. [. . . ]