User manual MOTOROLA T82 EXTREME TWIN

[. . . ] Before using this product, read the RF Energy Exposure and Product Safety Guide that ships with the radio which contains instructions for safe usage and RF energy awareness and control for compliance with applicable standards and regulation. Package Contents Package Content Radio Belt clip Lanyard Battery Power Supply Headset with boom mic RSM Stickersheet(16pcs) Owner’s manual Carrycase T82 T82 T82 T82 Extreme Extreme Extreme Quad RSM 2 2 2 2 1 2 0 1 1 1 4 4 4 4 2 4 0 2 1 1 2 2 0 2 1 0 2 1 1 1 Note: *Only Channels 1 to 8 are available by default. Channels 9 to 16 need to be activated by user before they can be selected. Channels 9 to 16 should only be used in countries where these frequencies are allowed by government authorities. [. . . ] Release the button after the beep, and wait for the transmission from the Leader’s radio. Note: • You will see the icon blinking on the display. This confirms that the radio is in Easy Pairing mode waiting to receive the Channel Selecting the Sub-Code Sub-Codes help minimize interference by blocking transmissions from unknown sources. Press Menu until the code starts to flash. You can hold down the button to speed up scrolling through the codes. On the Leader’s radio, press and hold down the until you hear a double beep. Button Note: • At the double beep, this radio’s Channel and Sub-Code settings will be transmitted, which will be received and copied by all the other (Members’) radios. € The Leader’s radio must make this transmission when all the Members’ radios are still in the Easy Pairing mode, otherwise the transmission will not be picked up. € On the Leader’s radio, user must remember NOT to release the button on the first (single) beep, otherwise this radio will become another Member’s radio. If that happens, you can press PTT to escape, and retry the steps described in #3 again. € If the Leader’s radio is set to a channel between 9 and 16, please ensure that all Members’ radios have channels 9 to 16 activated. € When a Member’s radio with only 8 Channels is being EasyPaired by a Leader’s radio on Channel 9 or above, Easy-Pairing will fail, indicated by three short beeps, and “Err” is displayed briefly. Note: When using iVOX/VOX, there will be a short delay. Dual Watch Enables you to scan the current channel and another channel alternately. Press or to select the channel then press Menu. Press the PTT button or wait until time out to activate Dual Watch. The screen will alternate between home channel and Dual Watch channel. Note: If you set the same channel and Sub-Code as the current channel, Dual Watch does not work. Internal Voice Operated Transmission/ Voice Operated Transmission ( / ) Transmission is initiated by speaking into the microphone of the radio/audio accessory instead of pushing the PTT button. L3 = High Sensitivity for quiet environments L2 = Medium Sensitivity for most environments L1 = Low Sensitivity for noisy environments Silent Mode (Vibrate Alert) Silent Mode (Vibrate Alert) notifies you that your radio is receiving a message. The Vibrate Alert will be triggered when you received a call. It will then only be triggered again if there is no activity within 30 seconds after the previous call. [. . . ] Tryk på knappen PTT for at forlade menuen eller på Menu for at fortsætte opsætningen. Tryk på knappen PTT for at forlade menuen eller på Menu for at fortsætte opsætningen. Tryk på knappen PTT for at forlade menuen eller på Menu for at fortsætte opsætningen. Tryk på knappen PTT for at forlade menuen eller på Menu for at fortsætte opsætningen. [. . . ]