User manual MOULINEX DKA 242

[. . . ] - Do not allow long hair, scarves, ties etc. to dangle over accessories during operation. - Disconnect your appliance as soon as you have finished using it, for cleaning and when fitting or removing accessories. - Do not use your appliance if it is not working correctly or if it has been damaged. [. . . ] - Stop the mincer by pressing position “0” of button (F). - Then press the “Reverse” button (G) for a few seconds to release the jam. - Press position “I” of button (F) to continue mincing. Important: wait until the appliance has stopped completely before pressing the “On” (F) or “Reverse” (G) button. Recipes: Note: For recipes requiring a high power, the appliance should not be run continuously for more than 20 seconds. In a bowl, mix the split peas and the flour and then add the water slowly to obtain a smooth mixture. With the pusher in the feed tube, pour this mixture into the hopper tray. Start the appliance and gently push the mixture down the feed tube with the pusher. Cut the onion, garlic and meat into small pieces. Add them to the minced mixture, turn into a saucepan with 800 ml water, add salt and pepper and simmer for one hour. Assembly 4a - Insert the feed screw (A2) in the body (A1) of the mincer head (A). 4b - Fit the kebbe making end (I1) to the head (A), locating the two lugs in the two notches in the mincer head. 4c - Fit the ring (I2) over the kebbe making end (I1), followed by the nut (A5), which must be well tightened. - Fit the assembled mincer head on the motor unit as shown in 2A. Assembly - Insert the feed screw (A2) in the body (A1) of the mincer head (A). - Fit the mould (J2) in the support (J1). - Locate the two lugs on the support (J1) in the two notches in the mincer head (A). Indd 10 06/01/10 11:20 - Screw the nut (A5) home on the body (A1) without locking. - Fit the assembled mincer head on the motor unit as shown in 2A. You will obtain the best results with a slightly soft dough. - Choose the shape by lining up the arrow with the chosen shape. - Keep feeding dough until you have obtained the desired number of biscuits. [. . . ] - Never allow water to penetrate the motor unit (H). Simply wipe it with a slightly damp cloth. - Do not put the mincer head (A) in the dishwasher; this applies to the body (A1), the feed screw (A2), the cutter (A3), the meat screens (A4) and the nut (A5). Indd 11 06/01/10 11:20 What to do if your appliance does not work - Check the electrical connection. [. . . ]