User manual MOULINEX FER PRINCIPIO 042511

[. . . ] The voltage of your electrical installation must correspond to that of the iron (220V-240V). Connecting to the wrong voltage may cause irreversible damage to the iron and will invalidate the guarantee. [. . . ] When ironing fabrics with mixed fibres, set the ironing temperature for the most delicate fibre Never exceed the water tank MAX level. Never use abrasive or aggressive products to clean the soleplate and the other parts of the iron. Your appliance has been designed to function with untreated tap water. If you have very hard water, mix untreated tap water with commercially available demineralised or distilled water in the following ratio: - 50% untreated tap water, - 50% demineralised or distilled water. Types of water not to use: Heat concentrates the elements contained in water during evaporation. The types of water listed below may contain organic waste, mineral or chemical elements that can cause spitting, brown staining or premature wear of the appliance: water from clothes dryers, scented or softened water, water from refrigerators, batteries, air conditioners, rain water, boiled, filtered or bottled water. These types of water should not be used in your Moulinex iron. Wait until the thermostat light goes out. Wait a few seconds between each use of the button. The chosen temperature is too low and does not allow for the formation of steam. You are using steam while the iron is not hot enough. You are using the Shot of Steam button too often. You have stored the iron horizontally, without emptying it and without setting it to . Brown streaks You are using chemical descaling come through the agents. [. . . ] Your linen has not been rinsed , sufficiently or you have ironed a new , garment before washing it. Aparatul dumneavoastr emite aburi care pot provoca arsuri, în special atunci când clcai pe un col al mesei de clcat. [. . . ]