User manual MOULINEX IM 3150

[. . . ] The wire which is coloured BROWN must be connected to the terminal which is marked with the letter `L' or coloured red. This appliance is manufactured to conform to the Low Voltage Electrical Equipment (Safety) Regulations 1989 and is designed to comply with BS 3456. it complies with the requirements of the EEC Directive (89/336/EEC). Any error in connecting the appliance invalidates the guarantee - Your appliance is for domestic use only. [. . . ] - If the mains lead is damaged, it must be replaced by the manufacturer, the after-sales service , or a qualified technician, to avoid any danger. - Do not place the appliance or the mains lead in water or under running water - Any operation other than cleaning and usual general maintenance must be carried out by a Moulinex approved service centre. Cleaning it before and after each use - Do not use appliance to suck up inflammable or explosive substances (liquid or gas) - Do not use the appliance to suck up hot residues (cinders, ashes etc. ) - Never suck up water or any other liquid or damp substances (e. Fold out the cover page of this leaflet. The numbers correspond to the descriptions of the various parts and functions described on the following pages. Assembling the tubes - Fit the two tubes together (H1) or (H2). If your appliance is equipped with a telescopic tube with ratchet system (H3) : - Push the slide switch and adjust the tube to the required length. - Release the slide switch : the tube will be locked in place. - To unlock the tube push the slide switch again : the 2 sections will slide apart. Attaching the flexible hose to the vacuum cleaner - Push the end of the pivoting head on the flexible hose (G1) into the attachment point on the vacuum cleaner. Changing the dust bag Your appliance is equipped with either a paper dust bag or a fabric dust bag (depending on model chosen). If you notice that the vacuum cleaner seems to be less efficient than usual, check the bag full indicator (C3) by selecting the maximum power and lifting the cleaning tool off the floor. 12 - Lift up the catch (C2) to gain access to the dust bag compartment and raise the cover. Moulinex has designed an extremely hygienic system to enable you to remove, carry and dispose of the full dust bag without touching it. 14 - Release the bag into the waste bin by pushing the bag 15 - If your appliance is fitted with a hygienic dust bag, close The bag by pulling on the flap before removing the bag holder from the vacuum cleaner Do not forget to regularly change the dust bag and the filters. The efficiency of your cleaner and the life of the motor depend on it. Fitting a new dust bag - Push the cardboard support of the new dust bag into the bag holder until it will go no further. - Reposition the bag holder with the dust bag fitted in the cleaner. If your appliance is fitted with a fabric dust bag follow the same instructions as above. Note : as the appliance is fitted with a safety device which checks that the "bag is in place" you cannot close the lid if the bag and bag holder are not fitted correctly. We recommend that you use only genuine Moulinex dust bags (Ref AP8) since they are specially designed to ensure optimum performance from your vacuum cleaner. [. . . ] We recommend that you use only genuine Moulinex dust bags (Ref AP8) since they are specially designed to ensure optimum performance from your vacuum cleaner. Changing the air outlet filter Depending on the model you have chosen your appliance is equipped with different types of filters : foam filter (F2) or electrostatic filter (F3). If your appliance is simply fitted with a foam filter, clean it regularly by tapping it to remove the dirt. If your appliance is also equipped with an electrostatic filter this retains even smaller particles and limits the redispersement of fine particles of dust. [. . . ]