User manual MOULINEX IM 4249

[. . . ] €¢ Never leave the appliance unsupervised when it is connected to a power source; if it has not cooled down for approximately 1 hour. €¢ Your appliance gives off steam, which may cause burns, especially when you are ironing on a corner of your ironing board. Never direct the steam towards people or animals. €¢ Your iron should be used and placed on a stable surface. [. . . ] Preparation Filling the water tank • Unplug your iron before filling it and set the steam control to Fill the tank up to the (fig. 2), place the iron flat and fill it (fig. Deploy the Easycord system • Your iron is equipped with the Easycord system to prevent the Always use the Easycord system for enhanced comcord trailing across the laundry and creasing it during ironing. €¢ Press the button located on the base (fig. 4) and the Easycord system is automatically deployed. You can now plug in your appliance and begin ironing. Use Adjust the temperature and the steam • Adjust the thermostat button (fig. 5), consulting the table It is normal for the indicator light to switch on below. It will go out when the and off during ironing soleplate is hot enough. 3 021417 IM42XX MOULI 18/10/06 16:29 Page 4 onto the linen: - turn off the steam when POSITION OF STEAM SETTING ironing silk or synthetic FABRIC POSITION THERMOSTAT CURSOR fabrics. - set it at the minimum LINEN MAX position for wool. 4 021417 IM42XX MOULI 18/10/06 16:29 Page 5 Maintenance and cleaning Cleaning the anti-calc valve (once a month) • Unplug your iron and empty the water tank. €¢ Soak the valve in a cup of white spirit vinegar or plain lemon juice for 4 hours. €¢ Rinse the valve under running water and Replace the anti-calc valve. Unplug your iron and let it cool down before cleaning it. The iron will not function without the anti-calc valve. GB Carry out the self-cleaning operation (once a month) To slow down scaling and • prolong the useful life of your iron, carry out the • self-cleaning operation once a month. €¢ • • • Unplug your iron, set the steam control to and fill the water reservoir to MAX. Place your iron on its heel, set the thermostat button to MAX, plug in your iron and wait for the indicator light to go out. Gently shake the iron over the sink until some of the water (along with impurities) runs out through the soleplate. At the end of the operation, put the anticalc cartridge back in place and then plug in your iron for 2 minutes on its heel to dry the soleplate. Cleaning the soleplate • Unplug the iron, and when the soleplate is just warm, wipe it Never use abrasive or aggressive products. [. . . ] In the holes of the soleplate Vacuum the holes of the soleplate from and are burning. Make sure that your laundry is rinsed sufYour linen has not been rinsed sufficiently or you have ironed a ficiently so as to remove any deposits of new garment before washing it. soap or chemical products on new clothes. Your are ironing with an inappropriate program (temperature too high). [. . . ]