User manual MOULINEX LM850D10 MASTERMIX

[. . . ] € The appliance will only start if the blender jug or accessory are correctly positioned on the motor unit (A). € Do not operate the blender if the lid and cap (C5 + C6) are not in place. 36 USING YOUR APPLIANCE • Moisten the seal (C3) and position it correctly onto the blade unit (C1). € Place the assembly (C1+C3) on the base of the jug (C4). [. . . ] Auto Clean: This function allows you to clean the jug. The blender works at various speeds alternating for 45 seconds, unless it is switched off manually by means of the on/off button or by pressing the Autoclean button again. Note that ice crush, smoothie and the auto clean functions cannot be activated, when you use the variable speed function. Turn the function selector to the required speed and start the blending by means of the on/off button. Switch off the blender by pressing the on/off button in the middle of the function button and turn the function button back to 0. € We recommend that you experiment to find the speed that is best for the ingredients to be mixed. Always check on the mixing and switch off the appliance, when the desired result has been obtained. € Never remove the glass jug while the motor is on. Do not operate the blender with only dry ingredients (e. Nuts) in the jug, as this may damage the blender. Always add a small amount of liquid before you operate the appliance. mixing of hot liquid • The glass jug can withstand hot ingredients and hot liquids/ soups. Be careful if hot liquid is poured into the blender as it can be ejected out of the appliance due to a sudden build up of steam. In order to avoid this, proceed as follows: 1. The temperature of the liquid in the blender should not exceed 80°C. Fill the jug half way up with the desired ingredients (e. Operate the blender at MIN setting and pour the liquid (hot stock, cream or similar) slowly through the opening in the lid. Do not switch off the blender while doing this. If the blender is switched off when the jug contains hot liquid and is restarted, pressure from the bottom may cause the lid to eject due to the high rotation of the motor. € If the blender has been switched off during the above process and needs to be restarted, place a towel, oven glove or similar over the jug and hold it down with your hand. When operating the blender remember that hot liquid may be ejected. € Hot liquids alone must not be processed in the blender, since the pressure in the jug will be too high. [. . . ] Solutions Plug the appliance into a socket and switch on. Check that the jug or accessories are correctly positioned and locked onto the motor unit as shown in the figure in the manual. Lock the lid correctly on the blender jug. Reposition the gasket and lock the blade holder correctly. [. . . ]