User manual MOULINEX MO 4021

[. . . ] Vacuum cleaner supply cords and winding systems must, in all cases, be replaced by our approved Service Centre. Repairs should only be carried out by specialists using original replacement parts. It is dangerous to try to repair an appliance by yourself. A - Horizontal parking b - Upright parking On/Off pedal Electronic power control Automatic cable rewind pedal Bag fill indicator Air exit grill Carrying handle Bag compartment Cover Suction opening Lip opening door Engine foam-filter protection Engine foam-filter grill protection HEPA filter cartridge* ref. [. . . ] To remove it, press the button of the hose connector and pull - fig. € Fit the appropriate accessory to the end of the tube: - For rugs and wall-to-wall carpeting: use the head (23) with brushes lifted - fig. - For parquets and smooth flooring: use the nozzle (23) with the brush extended - fig. - For furniture: use the mini-brush on the convertible slotted attachment* (25) or the furniture attachment* (24). € Adjust the suction power: - With the electronic power selector (3): Turn the button of the electronic power regulator to adjust the suction power: to the max position for floors and to the min position for furniture and delicate fabrics fig. - With the electronic power regulator on the power nozzle: open the selector switch flap to manually reduce suction power regulator, ex: fragile surfaces… - fig. STORING AND TRANSPORTING THE APPLIANCE • After use, stop your appliance by pressing on the on/off pedal (2) and unplug it - fig. Replace the cable by pressing the automatic cable rewind pedal (4) - fig. € In an upright position, hook the telescopic tube* (20) onto its storage position on the back of the appliance (1b) - fig. € You can transport your vacuum cleaner easily using its carrying handle (7). € In the horizontal position, hook the floor nozzle (23) onto its storage position at the rear of the appliance (1a) - fig. € Shake it and clean it, every ten dustbag changes, with tepid soapy water. € Let the foam-filter dry (12) completely before putting back in place. Make sure that the foam filter is completely dry before fitting it again. € Clean the housing of the vacuum cleaner with a soft and humid rag and let dry. € Clean the cover with a dry rag - fig. 1- The Hepa* filter cassette • Open the lid (9) of your vacuum cleaner fig. 22 and dispose of the cassette in a waste bin. € Check that the Hepa* filter cassette (14) is fitted correctly before re-closing the lid (9). 11 NoticeZÉLIO 7/06/07 14:43 Page 12 TROUBLESHOOTING 1. IF YOUR VACUUM CLEANER DOES NOT START • The appliance is not plugged-in, check that the appliance is correctly plugged in. € The electronic variable suction power selector is in the minimum position. [. . . ] 12 NoticeZÉLIO 7/06/07 14:43 Page 13 F THE ACCESSORIES* ACCESSORIES* Floor nozzle For hard and smooth floors. Fit the hardfloor tool to the end of the tube. VACUUMING FITTING AN ACCESSORY PURCHASE LOCATIONS Moulinex Approved Ser vice Centres (see the attached address list). Moulinex Approved Ser vice Centres (see the attached address list). [. . . ]