User manual MOULINEX MO5396PA COMPACTEO ERGO CYCLONIC

[. . . ] SAFETY RECOMMENDATIONS • For your safety, this appliance complies with all enforceable standards and regulations (Low Voltage Directives, Electromagnetic Compatibility, Environment, etc. EN CONDITIONS FOR USE • Your vacuum cleaner is an electrical device: it must be used under normal conditions of use. €¢ Use and store the appliance out of reach of children. Never leave the appliance operating without supervision. [. . . ] €¢ Open the lid (8) of your vacuum cleaner - fig. 14 • Remove the dust compartment (13) from its housing (7) using the grip zone (13a) - fig. EMPTY THE DUST COMPARTMENT Empty the dust compartment (13) after each use. €¢ Pull the dust compartment opening clip (13c) to open it - fig. €¢ Make sure no dust is left in the compartment, then wipe the edges of the compartment - fig. €¢ Close the dust compartment (13) and replace it in its housing (7) - fig. To optimise the efficiency of your vacuum cleaner, make sure you clean the foam (14a) each time you empty the dust compartment (13). €¢ Simultaneously pull on the HEPA filter capsule opening clips (13d) - fig. €¢ Separate the black foam filter (14a) from the HEPA filter (14b) - fig. €¢ Wash the black foam filter (14a) under the tap, squeeze it out like a sponge and leave to dry for 12 hours - fig. €¢ Once completely dry, assemble the HEPA filter capsule (14): black foam filter (14a) and HEPA filter (14b) under the dust compartment (13) - fig. 28a, and replace the compartment in its housing (7) - fig. The black foam filter (14a) should only be put back into the appliance when it is completely dry. You can use your vacuum cleaner while the black foam filter (14 a) is drying by using the replacement black foam filter: (14a bis). CLEAN THE DUST COMPARTMENT (13) AND THE AIR/DUST SEPARATOR (15) Important: Clean the dust compartment (13) and the dust separator (15) every month. €¢ Pull the dust compartment opening clip (13c) to open it - fig. 18a, unclip the HEPA filter capsule (14) by simultaneously pulling on the opening clips (13d) located at each end of the compartment - fig. €¢ Turn the compartment over and place the accessory* (18b) into the lock slot of the dust separator holder (17) - fig 20. €¢ Open, making sure you respect the unlocking direction ( ) - fig 21. • Remove the dust separator holder (16) - fig 22. €¢ Unclip then remove the dust separator (15) in the unlocking direction ( ) - fig-23. €¢ Then run the dust compartment (13), dust separator holder (16) and the dust separator (15) under clear or soapy water - fig 24a. [. . . ] €¢ Separate the microfilter * (12) from the motor protection grid (11) - fig. €¢ Discard the microfilter* (12) into a dustbin - fig. 33c and replace it with a new microfilter (REF. €¢ Place the new microfilter * (12) on the motor protection grid (11) - fig. [. . . ]