User manual MOULTRIE 135 GAMESPY

[. . . ] However, interference may occur in a particular installation. If this equipment does interfere radio or television reception , the user is encouraged to correct the interference by the following steps: Reorient the antenna of the radio or television Relocate the computer to match the radio or television receiver Plug the computer into a different power outlet If necessary, the user should consult with the dealer or an experienced radio/television technician for help and suggestions. The user may find the following booklet, prepared by the FCC, helpful in solving radio/television interference problems: "How to Identify and Resolve Radio-TV Interference Problems" This booklet is available by sending a written request to: U. S. Government Printing Office Washington D. C. , 20402 Request Stock Number 004-000-0345-4. ECC Statement This device complies with the requirements of EEC directive 89/336/EEC with regard to Electromagnetic Compatibility. [. . . ] With a USB cable, you can transfer all the pictures and sounds to your PC. Installing Batteries Your camera is powered by 2 AAA batteries or by a PC via a USB cable. ***Notes *** When batteries are removed, all of the stored pictures and sounds are cleared. Then press the shutter switch to play recorded sound. Change mode to "AP" "AP" is displayed Press SW1 to play recorded voice Delete the last stored Press the mode switch until the LCD changes to indicate "dP", "dA" or "dC". When pressing the shutter switch, the LCD starts blinking. Press the shutter switch again within 5 seconds and your camera deletes the last stored image, sound or continuous snapshot. Change mode to "dP", "dA" or "dC" "dP", "dA" or "dC" is displayed Press SW1 twice to delete the last stored @n IP Company Self Timer Press the mode switch until "St" appears on the LCD. Then press the shutter switch and a 10 second self-timer starts. Every 10 second the camera issues a short beep. When completing the self-timer, a longer beep sounds, which indicates that a picture is taken. Note: The self-timer can't work when the memory of your camera is full. SW1 Change mode to "St" "St" is displayed Press SW1 to initiate the self-timer mode Continuous mode Press the mode switch until "Ct" appears on the LCD. You can take a series of pictures in quick succession by holding down the shutter switch. The function stops as you release the shutter switch. = Press "Video Format" button to set image size. = Press "Snap Shot" button to image to the album window. capture an = Press "Record button" to record a video clip to album window. DSC Mode Transferring Photos & Voice: This allows you to transfer photos in your camera. < Press the "Link" button to connect the camera and transfer photos & sounds. = Press the "Album" button to open the album window. > Press the "Transfer all" or "Transfer selected" button to transfer photos or sounds to the album window. = Transfer pictures and sounds in your camera to your PC. Open or close album window = Transfer selected photos and sound to album window = Transfer all photos and sound to album window @n IP Company Enhanced Resolution Mode: . The Largest Resolution : XGA( 800K pixels ) . Optical Resolution: VGA ( 300K pixels) Your camera has particular enhanced image skills, which make images sharper by enhancing the original VGA image to XGA image. How to operate: Click the setting button. Choose " Enhanced resolution ". [. . . ] Any attempt by the end user to disassemble any part of the HARDWARE PRODUCT, decompile any part of the software included with the HARDWARE PRODUCT, or damage any piece of the HARDWARE PRODUCT (including but not limited to accidental damage, incidental damage, purposeful damage, or damage caused by a person other than the End-User), shall immediately and irrevocably void the Limited Warranty. MOULTRIE shall then be released from honoring any and all parts of this Limited Warranty, and the End-User will be ineligible for both the Warranty Service, and will also be ineligible for receiving Technical Support. The Limited Warranty cannot be transferred to another individual from the original purchaser, except as provided in the END-USER LICENSE AGREEMENT. If the HARDWARE PRODUCT is sold to another user by the original End-User, the Limited Warranty will be null and void, and MOULTRIE will have no obligation to provide the Warranty Service. [. . . ]