User manual MPMAN DAB200

[. . . ] The mains plug is used as the disconnect device and it must remain readily operable. To completely disconnect the power input, the mains plug of the apparatus must be disconnected from the mains. the normal function of the product may be disturbed by Strong Electro Magnetic Interference. If so, simply reset the product to resume normal operation by following the instruction manual. [. . . ] Press the or buttons to move through the DAB channels, the display will show "5A to 13F" and their associated frequencies. DAB secondary services On some occasions you will see a ">" symbol directly after the name of the station, this indicates that there are secondary services available to that station. The secondary services are inserted directly after the primary station. DAB display modes Every time you press the DISPLAY/INFO button, the display will cycle through the following display modes: DLS DLS stands for Dynamic Label Segment which is a scrolling message that the broadcaster may include in their transmissions. Signal strength The display will show a slide bar to indicate the signal strength, the stronger the signal, the longer the bar will be from left to right. Ensemble/Multiplex (Group name) The Ensemble/Multiplex is a collection of radio stations that are bundled and transmitted together in a single frequency. There are national and local multiplexes, local ones contain stations that are specific to that area. Note: Press and hold the DISPLAY/INFO button for longer than 2 seconds, the software version number will be displayed. To activate auto search, press and hold the I or I buttons until it starts to scan down or up the frequency band, it will stop automatically once a station has been found. Note: The radio will automatically switch between stereo and mono mode, but you can override this and switch this function manually which is helpful for poor signal reception. STORING AND RECALLING PRESET STATIONS In either DAB or FM, you can store up to 10 stations to the favourite presets; this will enable you to get direct access to your favourite stations. To store a preset, first tune to your desired station, then press and hold the PROGRAM button until the display shows the preset number and flash. Finally press the PROGRAM button to confirm your selection, the display will show "Preset # stored". To recall a preset station that you have stored, press the PRESET +/- buttons on the remote, the display will show the preset number and the associated information. It would tune to the station in one second after the buttons are released. FACTORY RESET When you move the system to another part of the country, your pre-tuned and stored DAB stations may no longer be available. If this is the case then you will need to reset your system back to its original factory settings; to perform a factory reset, please do the following: 1. Connect the unit to mains and press the STANDBY/ON button once to turn the unit on. Ensure the unit is in DAB mode, then press and hold the MENU button until the display shows "Press SELECT to confirm reset". Release the MENU button and press the SELECT button once, the display will show "Restarting. After the scan has finished, the radio will select and display the first alphanumerically found station. Note: All of your stored DAB & FM presets will be lost once the reset has taken place. [. . . ] To set the timer, press and hold the TIMER button until the display shows "Timer Set" and the "hour" digit of the timer clock in the display will flash. Press the or buttons to set the time and press the TIMER button to confirm, first set the hour and then the minute. When the time to switch on the system is set, the display will show the timer on mode and flash, press the or buttons to select the mode (CD/FM/DAB), then press the TIMER button to confirm and the timer on mode is set 5. The display will show the volume level and flash, press the or buttons to select the timer on volume level, then press the TIMER button to confirm and the timer setting is now completed. [. . . ]