User manual MR COFFEE JWX3

[. . . ] T reduce the risk of fire, electric shock and/or injury to persons, basic o safety precautions should always be followed when using electrical appliances, including the following: 1. Use handles or knobs and do not open the lid or cover while brewing. Scalding may occur if the lid is removed during brewing cycles. T protect against electric shock, do not immerse the power cord, o power plug or coffeemaker in water or in any other liquid. [. . . ] This serves to remind you to change the disk every month. 30 brewing cycles) NOTE: For optimum results, use the water filtration system with a permanent filter. Rinse the water filter in fresh water before first use. When you are done brewing your coffee, rinse the water filter with fresh water. Do not put your water filter in the dishwasher. To replace the water filter disks, twist the gray disk cover from your water filtration system. Insert the new disk into the frame and twist the cover back into place. For your convenience, you can lift out the removable filter basket. (Figure 2) NOTE: If using paper filters, it is important that the sides of the filter fit flush against the side of the filter basket. If filter collapse occurs, dampen the filter before placing in the filter basket and adding ground coffee and water. Add the desired amount of coffee and gently shake to level the (Figure 2 - Adding water coffee. Be sure the filter basket is properly centered and all the way down in the filter basket. Fill the decanter with cold, fresh water to the desired capacity (1 cup equals 5 ounces). For easy and accurate filling, the water markings on the glass decanter and on the dual water windows show the amount of water needed to make the corresponding desired number of cups. Do not fill past the "MAX line" or water will flow out of the overfill hole in the back of the water reservoir. The amount of coffee brewed will always be slightly less than the amount of water poured in the water reservoir. This is due to the minimum absorption of water by the coffee grounds. Close the lid and place the empty decanter onto the warming plate. NOTE: Make sure the decanter is fully placed on the warming plate or the water and the grounds will overflow from the filter basket. T reduce the risk of damaging the decanter and/or the risk of personal injury, do o not add cold water to the decanter if the decanter is already hot. Allow the decanter to cool before using. After completing the steps in the Adding Water and Coffee section and with the glass decanter and filter basket secure in place, turn the coffeemaker on by pressing the BREW NOW button once. [. . . ] tHE COFFEE IS NOT BREWING The appliance is unplugged. The decanter is not placed all the way in on the warming plate. THE COFFEEMAKER ONLY BREWS WATER THE COFFEEMAKER BREWS SLOWLY THE FILTER BASKET OVERFLOWS There are no coffee grounds in the filter basket. The decanter is not placed all the way in on the warming plate. [. . . ]