User manual MR COFFEE UTC403

[. . . ] IMPORTANT safety precautions should always be followed to reduce the risk of fire, SAFEGUARDS When using electrical appliances, basic electric shock, and/or injury to persons, including the following: 1. Read all instructions before using the machine. To reduce the risk of fire or electric shock, do not place any electric or gas-heating appliance beneath the coffeemaker. To reduce the risk of fire, do not mount unit over or near any portion of a heating or cooking appliance. [. . . ] Carefully sand or file the edges smooth. Locate the 2 SUPPORT PLATES and place them inside the cabinet, flat side down, aligned over the drillholes. Insert one nut into each bracket slot (FIGURE E). Position brackets beneath screws and tighten enough to leave some movement in the brackets for final adjustment. Rotate the vent knob in the rear of the coffeemaker so that the arrow points down (vent open). `13. Gently push the coffeemaker fully up onto the brackets, aligning the brackets with the coffeemaker slots. The coffeemaker will lock into position. 4 `CENTERLINE A. B. Cut along line denoting your overhang depth. 4 D. Secure the power cord against the cabinet bottom or rear wall by using the two Adhesive-backed cord clips. Removing The Coffeemaker 1. Remove the glass decanter and brew funnel. After use, allow the coffeemaker to cool completely. Grasp the bottom left and right edges and depress the 2 BRACKET RELEASE BUTTONS. Lower the coffeemaker off the brackets. IMPORTANT, THE CLOCK ON THIS MODEL MUST BE SET FIRST, BEFORE THE COFFEEMAKER WILL OPERATE. Please refer to setting the clock instructions, below. Setting the Clock and Timer The clock in this appliance includes an automatic brew start mode (AUTO) with a safety feature to prevent accidental turn-on the following day if it is mistakenly left in the AUTO mode from. a previous use. PM Indicator Brew Light!indicates when coffeemaker is ON Control Switch ON-OFF-Automatic Start Hour advances clock by the hour /Auto Off Light indicates machine shut itself off Brew Set sets time to auto brew Minute advances clock by minute TO SET CLOCK. . Plug the power cord into your electrical outlet. The display on the clock will flash until you set the time. Alternately press and hold the HOUR and MINUTE buttons until you reach the current time. A red dot will appear in the upper left display corner for PM time. Press and hold the BREW SET button while pressing the HOUR and M!, NUTE buttons to set the desired brew starting time. Please pay attention to PM INDICATOR light. Follow steps #l through #6 in "How to-Brew Coffee". [. . . ] Use only a damp cloth to wipe. Don'ts. . . . . . Do NOT place a cloth or otherwise restrict airflow beneath the appliance. Never reheat a beverage by passing it through the brewing system. Do not use abrasive or caustic cleaning compounds to clean the exterior of the unit. Do not store the machine until warmer plate has cooled. Helpful Hints ! [. . . ]