User manual MSI H61M-E23

[. . . ] X) Mainboard G52-77881X1  Copyright Notice The material in this document is the intellectual property of MICRO-STAR INTERNATIONAL. We take every care in the preparation of this document, but no guarantee is given as to the correctness of its contents. Our products are under continual improvement and we reserve the right to make changes without notice. Trademarks All trademarks in this manual are properties of their respective owners. [. . . ] Then push down the power supply firmly into the connector. G 2 ATX 4-Pin Power Connector: JPWR2 This 12V power connector is used to provide power to the CPU. +1 4 Important Make sure that all the connectors are connected to proper ATX power supplies to ensure stable operation of the mainboard. serial ATA Connector: SATA1~4 This connector is a high-speed Serial ATA interface port. Each connector can connect to one Serial ATA device. Important Please do not fold the Serial ATA cable into a 90-degree angle. Otherwise, data loss may occur during transmission. 18 MS-7788 Fan Power Connectors: CPUFAN1, SYSFAN1, SYSFAN2 The fan power connectors support system cooling fan with +12V. When connecting the wire to the connectors, always note that the red wire is the positive and should be connected to the +12V; the black wire is Ground and should be connected to GND. If the mainboard has a System Hardware Monitor chipset onboard, you must use a specially designed fan with speed sensor to take advantage of the CPU fan control. cPUFAN1/ SYSFAN2 SYSFAN1 Parallel Port Connector: JLPT1 (optional) This connector is used to connect an optional parallel port bracket. The parallel port is a standard printer port that supports Enhanced Parallel Port (EPP) and Extended Capabilities Parallel Port (ECP) mode. R 1 19 Front USB Connector: JUSB1/ JUSB2 This connector, compliant with Intel® I/O Connectivity Design Guide, is ideal for connecting high-speed USB interface peripherals such as USB HDD, digital cameras, MP3 players, printers, modems and the like. Press DEL to enter Setup Menu If the message disappears before you respond and you still wish to enter Setup, restart the system by turning it OFF and On or pressing the RESET button. You may also restart the system by simultaneously pressing <Ctrl>, <Alt>, and <Delete> keys. Important The items under each BIOS category described in this chapter are under continuous update for better system performance. Therefore, the description may be slightly different from the latest BIOS and should be held for reference only. The Menu Bar Main Menu Use this menu for basic system configurations, such as time, date etc. Advanced Use this menu to set up the items of special enhanced features. Overclocking Use this menu to specify the settings for DRAM timing and CPU features. 23 M-Flash Use this menu to read/ flash the BIOS form storage drive (FAT/ FAT32 format only). Security Use this menu to set supervisor and user passwords. [. . . ] Short duration power limit (W) This field allows you to adjust the TDP power limit for the short duration. Primary/ Secondary plane turbo power limit (W) These fields allow you to adjust the TDP limit for the primary/ secondary plane turbo. Save & Exit Discard Changes and Exit Use this item to abandon all changes and exit setup. Save Changes and Reset Use this item to save changes and reset the system. [. . . ]