User manual MSI MS-7528 V1.0

[. . . ] G31M3 series MS-7528 (v1. X) Mainboard G52-75281X1 i Copyright Notice T he material in this doc ument is the intellec tual property of M ICRO-STAR INTERNATIONAL. We take every care in the preparation of this document, but no guarantee is given as to the correctness of its contents. Our products are under continual improvement and we reserve the right to make changes without notice. Trademarks All trademarks are the properties of their respective owners. NVIDIA, the NVIDIA logo, DualNet, and nForce are registered trademarks or trademarks of NVIDIA Corporation in the United States and/or other countries. [. . . ] It can only be used by the graphics core. [DVMT] mode, the driver of the graphics core uses the system memory like any other OS component or application does. DVMT/FIXED Memory Specify the size of DVMT memory to allocate for video memory. Boot Sequence Press <Enter> to enter the sub-menu: 1st/ 2nd/ 3rd/ 4th Boot Device The items allow you to set the first/ second/ third boot device where BIOS attempts to load the disk operating system. 3-10 BIOS Setup Boot From Other Device Setting the option to [Yes] allows the system to try to boot from other device. if the system fails to boot from the 1st/ 2nd boot device. Trusted Computing Press <Enter> to enter the sub-menu: TCG/TPM SUPPORT This setting allows you to enable/disable the TCG/TPM. Excute TPM Command This item allows you to enable or disable the TPM security chip. Clearing the TPM This item allows you to clear the user information saved in the TPM security chip. W hen you press <Enter>, a warning message will appear to ask if you want to clear the user information in the security chip. Use the left / right arrow key to select between [OK] and [Cancel], then press <Enter> to confirm your choice. TPM Enable/Disable Status This item is not configurable. TPM Owner Status This item is not configurable. 3-11 M S-7528 M ainboard Integrated Peripherals USB Controller This setting allows you to enable/disable the onboard USB controller. USB Device Legacy Support Select [Enabled] if you need to use a USB-interfaced device in the operating system. Onboard LAN Controller This item is used to enable/disable the onboard LAN controller. LAN Option ROM This item is used to decide whether to invoke the Boot ROM of the LAN controller. Onboard IEEE1394 Controller This item allows you to enable/disable the onboard IEEE1394 controller. Audio Controller This setting is used to enable/disable the onboard audio controller. On-Chip ATA Devices Press <Enter> to enter the sub-menu: On-Chip IDE Controller These items allow users to enable or disable the IDE controller. PCI IDE BusMaster This item allows you to enable/ disable BIOS to used PCI busmastering for reading/ writing to IDE drives. 3-12 BIOS Setup On-Chip SATA Controller These items allow users to enable or disable the SATA controller. RAID M ode This item is used to enable/disable the RAID function for SATA devices. I/O Device Configuration Press <Enter> to enter the sub-menu: COM Port 1/2 Select an address and corresponding interrupt for the first serial port. Parallel Port There is a built-in parallel port on the on-board Super I/O chipset that provides Standard, ECP, and EPP features. [. . . ] Please note that the existing data on the selected hard drive(s) will be deleted permanently. Do not forget to back up all the important data before continuing. B-19 M S-7528 M ainboard (4) Specify Volume Size Specify the amount of available array space to be used by the new RAID volume. You may enter the amount in the space or use the slider to specify. It is recommended you use 100% of the available space for the optimized usage. [. . . ]