User manual MSI MS-7599 G52-75991XF V2.1

[. . . ] We take every care n the preparaton of ths document, but no guarantee s gven as to the correctness of ts contents. Our products are under contnual mprovement and we reserve the rght to make changes wthout notce. If a problem arses wth your system and no soluton can be obtaned from the user's manual, please contact your place of purchase or local dstrbutor. Alternatvely, please try the followng help resources for further gudance. [. . . ] If you'd lke to use the 20-pn ATX power supply, please plug your power supply along wth pn 1 & pn 13. Ths connector s used to provde power to the CPU. Make sure that all the connectors are connected to proper ATX power supples to ensure stable operaton of the manboard. You can attach a seral mouse or other seral devces drectly to the connector. It s easy to dfferentate between audo effects accordng to the color of audo jacks. Lne-In (Blue) - Lne In, s used for external CD player, tape-player or other audo devces. If you nstall two IDE devces on the same cable, you must configure the drves separately to master / slave mode by settng jumpers. Each connector can connect to one Seral ATA devce. To clear the warnng, you must enter the BIOS utlty and clear the record. The fan power connectors support system coolng fan wth +12V. When connectng the wre to the connectors, always note that the red wre s the postve and should be connected to the +12V; the black wre s Ground and should be connected to GND. If the manboard has a System Hardware Montor chpset on-board, you must use a specally desgned fan wth speed sensor to take advantage of the CPU fan control. You can nstall Overclockng Center utlty that wll automatcally control the CPU fan speed accordng to the actual CPU temperature. ⷠFan cooler set wth 3 or 4 pns power connector are both avalable for CPUFAN. These connectors are for electrcal connecton to the front panel swtches and LEDs. Ths connector allows you to connect the front panel audo and s complant wth Intel® Front Panel I/O Connectvty Desgn Gude. There s a CMOS RAM onboard that has a power supply from an external battery to keep the data of system configuraton. Wth the CMOS RAM, the system can automatcally boot OS every tme t s turned on. If you want to clear the system configuraton, set the jumper to clear data. You can clear CMOS by shortng 2-3 pn whle the system s off. Ths secton wll explan how to change your manboard's functon through the use of swtch. Follow the nstructons below to set the FSB. [. . . ] start OC Steppng From (MHz) Ths tem s used to set the ntal FSB clock. The system wll boot wth the ntal FSB clock, and start to overclock from ntal FSB clock to set FSB clock that you set n "Adjust CPU Base Frequency (MHz)" step by step. OC Step Ths tem s used to set how many steps for FSB colck overclockng. OC Step Count Tmer Ths tem s used to set the buffer tme for every step. [. . . ]