User manual MSI N630GT-MD1GD3

[. . . ] 1 Revision History First release for Europe Change cover Date October 2010 December 2010 Technical Support If a problem arises with your system and no solution can be obtained from the user’s manual, please contact your place of purchase or local distributor. Alternatively, please try the following help resources for further guidance. — ◙ Visit the MSI website for FAQ, technical guide, BIOS updates, driver updates, and other information: http://www. Func=service Contact our technical staff at: http://ocss. [. . . ] With SuperCharger technology, the JUSB1 can only provide charging function in S0 (power-on), S3 (sleep mode) & S5 (shut-down) states. However, the synchronizing data link will be disabled. In this case, the system can not be awaked through the JUSB1. € For Super-Charger in S3 (sleep mode)/ S5 (shut-down), we suggest you to connect only one device for stable charging. € Super-Charger technology would be available on specific models, please refer to MSI website for model support list. 0 Bracket (optional) Important • Note that the pins of VCC and GND must be connected correctly to avoid possible damage. IEEE1394 Connector: J1394_1 (optional) This connector allows you to connect the IEEE1394 device via an optional IEEE1394 bracket. 1394 Bracket (optional) En-18 115V * The MB layout in this figure is for reference only. * The MB layout in this figure is for reference only. N 1 S/PDIF-Out Connector: JSP1 This connector is used to connect S/PDIF (Sony & Philips Digital Interconnect Format) interface for digital audio transmission. S/PDIF-Out Bracket (optional) Serial Port Connector: JCOM1 This connector is a 16550A high speed communication port that sends/receives 16 bytes FIFOs. En-23 MS-7681 Mainboard Voltage Check Point: FV1 (optional) This voltage check point set is used to measure the current CPU/ CPU_VTT/ CPU_SA/ DDR/ PCH voltage. CPU 1 CPU_SA PCH GND 7 CPU_VTT DDR GND 1 7 CPU GND CPU voltage: measure the current CPU voltage with CPU point and GND point by using a multimeter. 1 7 CPU_VTT GND CPU_VTT voltage: measure the current CPU_ VTT voltage with CPU_VTT point and GND point by using a multimeter. 1 7 CPU_SA GND CPU_SA voltage: measure the current CPU_SA voltage with CPU_SA point and GND point by using a multimeter. 1 7 DDR GND DDR voltage: measure the current DDR voltage with DDR point and GND point by using a multimeter. 1 7 PCH GND PCH voltage: measure the current PCH voltage with PCH point and GND point by using a multimeter. en-24 Slots PCIE (Peripheral Component Interconnect Express) Slot The PCIE slot supports the PCIE interface expansion card. English PCIE x16 Slot PCIE x1 Slot PCI (Peripheral Component Interconnect) Slot The PCI slot supports LAN card, SCSI card, USB card, and other add-on cards that comply with PCI specifications. 32-bit PCI Slot Important When adding or removing expansion cards, make sure that you unplug the power supply first. Meanwhile, read the documentation for the expansion card to configure any necessary hardware or software settings for the expansion card, such as jumpers, switches or BIOS configuration. PCI Interrupt Request Routing The IRQ, acronym of interrupt request line and pronounced I-R-Q, are hardware lines over which devices can send interrupt signals to the microprocessor. [. . . ] for further information please refer to Intel’s official website. – Power Technology This item allows you to select the Intel Dynamic Power technology mode. – C1E Support To enable this item to read the CPU power consumption while idle. Not all processors support Enhanced Halt state (C1E). [. . . ]