User manual MTD 379

[. . . ] OPERATOR’S MANUAL 21” Self-Propelled Mower Model Number 379 IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forestcovered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator. In the State of California the above is required by law (Section 4442 of the California Public Resources Code). A spark arrester for the muffler is available through your nearest engine authorized service dealer or contact the service department, P. O. [. . . ] Hold control handle down and pull rope firmly to start the engine. Set cutting height adjustment lever to middle setting and mow a single pass on your lawn; then adjust to desired height for a closer cut. To mulch insert the mulch plug/cover on the mower. Before storing the lawn mower for the winter, use stabilizer-treated fuel and run the tank dry. Thirty days before start of the new season, check the air filter, spark plug and blade on the lawn mower, and replace if needed. Never fill fuel tank indoors with engine running or until the engine has been allowed to cool for at least two minutes after running. WARNING: Keep hands and feet away from chute area on the cutting deck. The operation of any lawn mower can result in foreign objects being thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields. NOTE: For shipping purposes your mower is set with the wheels in a low cutting height position. For best results raise the cutting position until it is determine which height is best for your lawn. See the adjustment section for details. Before Starting Your Mower • Attach spark plug wire to spark plug. Make certain the metal cap on the end of the spark plug wire is fastened securely over the metal tip on the spark plug. Check for proper drive clutch operation using the NEUTRAL ADJUSTMENT TEST. • Neutral Adjustment Test To perform the neutral adjustment test answer the following questions. • With the drive clutch control released, push mower forward and pull it backward. Does it move freely? Gas and Oil Fill-Up Service the engine with gasoline and oil as instructed in the separate engine manual packed with your mower. Read instructions carefully. 9 • • • • Squeeze the drive clutch control and pull the mower backward. Is the drive clutch control cable free of kinks or sharp bends?If you answered “yes” to all three questions, your mower passed the test and you can start your mower. If you answered “no” to any of the three questions, you will have to adjust the drive clutch control as instructed in the ADJUSTMENT SECTION. Mulching For effective mulching, do not cut wet grass because it tends to stick to the underside of the deck, preventing proper mulching of grass clippings. New or thick grass may require a narrower cut. The ground speed should be adjusted to the condition of the lawn. If mowing has been delayed and the grass has been allowed to grow in excess of 4”, mulching is not recommended. [. . . ] Normal wear parts and components include, but are not limited to: batteries, belts, blades, blade adapters, grass bags, rider deck wheels, seats, snow thrower skid shoes, shave plates, auger spiral rubber, and tires. HOW TO OBTAIN SERVICE: Warranty service is available, WITH PROOF OF PURCHASE, through your local authorized service dealer. To locate the dealer in your area, check your Yellow Pages, or contact Cub Cadet LLC at P. O. Box 361131, Cleveland, Ohio 44136-0019, or call 1-877-282-8684, or log on to our Web site at www. cubcadet. com. [. . . ]