User manual MTD 13A278M710

[. . . ] OPERATOR’S MANUAL SERIES 2000 TRACTOR Model Number GT 2521 w/48" Mower Deck IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forestcovered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator. In the State of California the above is required by law (Section 4442 of the California Public Resources Code). A spark arrester for the muffler is available through your nearest engine authorized service dealer or contact the service department, P. O. [. . . ] Apply a light coating of clean oil on the gasket of the new oil filter. Thread the filter on by hand until the gasket contacts the oil filter adapter, then tighten the filter an additional 1/2 to 3/4 turn. Refer to FILLING THE CRANKCASE and to the LUBRICATION TABLE then refill the crankcase with the quantity and type of oil specified. 4. Securely screw the oil filler cap into the valve cover and the dipstick into the tube. CAUTION The oil fill cap and dipstick must be tightened securely when the engine is operating. Severe engine damage could result from failure to do so. Start the tractor engine and allow it to run for 30 seconds, then stop the engine and remove the ignition key. Check the oil level and add oil if necessary. Check the oil filter and drain valve for leaks. CHECKING TRANSMISSION OIL LEVEL NOTE Check the oil level only while the engine is stopped and the tractor is level. Check the oil level of the transmission case before each use to see that it is filled to the correct level. Before checking the transmission oil level, clean the area around the oil fill plug/dipstick to prevent debris from entering the transmission case. Always keep the oil level between the “FULL” and the “ADD” marks on the dipstick (See Figure 23). When checking the oil level, the dipstick must be withdrawn and wiped clean, then inserted all the way before being withdrawn for a true reading. F FILLING THE CRANKCASE CAUTION Never overfill the engine crankcase. The engine may overheat and/or damage may result if the crankcase is below the “LOW” mark or over the “FULL” mark on the dipstick. For best results, fill to the “FULL” mark on the dipstick as opposed to adding a given quantity of oil. Always check the level on the dipstick before adding more oil. Refer to the LUBRICATION TABLE for information regarding the oil capacity and the proper type of oil to pour into the crankcase. Place the tractor on a level surface and engage the brake pedal lock. Stop the tractor engine and remove the ignition key. Clean the area around the oil filler cap and the dipstick to prevent debris from entering the crankcase. Remove the oil filler cap from the valve cover and SLOWLY pour in oil. The oil capacity is approximately 1-1/2 quarts. [. . . ] Transportation charges and service calls. b. c. e. No implied warranty, including any implied warranty of merchantability or fitness for a particular purpose, applies after the applicable period of express written warranty above as to the parts as identified. No other express warranty, whether written or oral, except as mentioned above, given by any person or entity, including the dealer, with respect to any product, shall bind CUB CADET. During the period of the warranty, the exclusive remedy is repair or replacement of the product as set forth above. [. . . ]