User manual MTD GT2186-44

[. . . ] OPERATOR’S MANUAL SERIES 2000 TRACTOR Model Number GT 2186-44 w/44" Mower Deck IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forestcovered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator. In the State of California the above is required by law (Section 4442 of the California Public Resources Code). A spark arrester for the muffler is available through your nearest engine authorized service dealer or contact the service department, P. O. [. . . ] Always check the level on the dipstick before adding more oil. Refer to the LUBRICATION TABLE for information regarding the oil capacity and the proper type of oil to pour into the crankcase. Place the tractor on a level surface and engage the brake pedal lock. Stop the tractor engine and remove the ignition key. Clean around the oil level dipstick, dipstick tube, and the oil filler cap to prevent debris from entering the crankcase. Remove the oil filler cap from the left valve cover and SLOWLY pour in oil. The oil capacity is approximately 4 pints. Fill the crankcase until the oil level reaches the “FULL” mark on the dipstick (Refer to Figure 18). Reinstall the oil filler cap by screwing it securely into the valve cover. NOTE The oil filler cap MUST BE TIGHTENED SECURELY INTO THE VALVE COVER AT ALL TIMES WHEN THE ENGINE IS OPERATING. Severe engine damage could result from failure to do so. Start the tractor engine and allow it to run for 30 seconds, then stop the engine and remove the ignition key. Check the oil level and add oil if necessary. Check the oil filter and drain valve for leaks. 25 CHECKING TRANSMISSION OIL LEVEL Refer to the LUBRICATION TABLE for information regarding the proper type of oil to add to the transmission case. Place the tractor on a level surface and engage the brake pedal lock. Stop the tractor engine and remove the ignition key. Clean the area around the oil fill plug/dipstick to prevent debris from entering the transmission case. Remove the oil fill plug/dipstick from the oil fill port and SLOWLY pour oil into the oil fill port. Fill the transmission case until the oil level reaches the “FULL” mark on the dipstick (Refer to Figure 20). Reinstall the oil fill plug/dipstick securely into the oil fill port. NOTE Check the oil level only while the engine is stopped and the tractor is level. Check the oil level of the transmission case before each use to see that it is filled to the correct level. Before checking the transmission oil level, clean the area around the oil fill plug/dipstick to prevent debris from entering the transmission case. Always keep the oil level between the “FULL” and the “ADD” marks on the dipstick (See Figure 20). [. . . ] Replacement parts that are not genuine Cub Cadet parts. Service completed by someone other than an authorized service dealer. Transportation charges and service calls. b. c. e. No implied warranty, including any implied warranty of merchantability or fitness for a particular purpose, applies after the applicable period of express written warranty above as to the parts as identified. [. . . ]