User manual MTD 400132-88 PARTS LIST

[. . . ] This unit is factory equipped with a spark arrestor. It will help you assemble, prepare and maintain the unit for best performance. Please read and understand what it says. Before you start assembling your new equipment, please locate the model plate on the equipment and copy the information from it in the space provided below. [. . . ] Allow the tip of the line to do the cutting, especially along walls. Cutting with more than the tip will reduce cutting efficiency and may overload the engine. € Cut grass over 8 inches (200 mm) by working from top to bottom in small increments to avoid premature line wear or engine drag. € Cut from right to left whenever possible. Cutting to the left improves the unit's cutting efficiency. Clippings are thrown away from the operator. € Slowly move the trimmer into and out of the cutting area at the desired height. € Trim only when grass and weeds are dry. € The life of your cutting line is dependent upon: • Following the trimming techniques • What vegetation is being cut • Where vegetation is cut For example, the line will wear faster when trimming against a foundation wall as opposed to trimming around a tree. 17 ADJUSTING TRIMMING LINE LENGTH The Bump Head™ cutting attachment allows you to release trimming line without stopping the engine. To release more line, lightly tap the cutting attachment on the ground (Fig. The line may not release properly if the line is too long. Top View Of The SpeedSpool® Arrows Outer Spool Winding the Inner Reel With New Line NOTE: It Is unnecessary to remove the bump knob to install a new trimming line. 41 mm) trimming line, 10 feet (3 m) long. Hold the outer spool and turn the inner reel counterclockwise to line up the arrows on the outer spool and inner reel (Fig. Pull old line out of the line loading and line locking holes (Fig. Insert a piece of trimming line into one of the two eyelets in the outer spool. Push it up through the line loading hole in the inner reel (Fig. Do not bend the line when inserting it into the eyelet. Repeat procedures 4-6 with the second piece of line. Wind the inner reel counterclockwise until approximately four (4) inches (102 mm) of line remain (Fig. NOTE: Do not wind the inner reel before installing the second piece of line. [. . . ] € Any manufacturer approved replacement part may be used in the performance of any warranty maintenance or repair of emission related parts and will be provided without charge to the owner. Any replacement part that is equivalent in performance or durability may be used in non-warranty maintenance or repair and will not reduce the warranty obligations of the manufacturer • The following components are included in the emission related warranty of the engine, air filter, carburetor, primer, fuel lines, fuel pick up/ fuel filter, ignition module, spark plug and muffler. 25 MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by Troy-Bilt LLC with respect to new merchandise purchased and used in the United States, its possessions and territories. Troy-Bilt LLC warrants this product against defects in material and workmanship for a period of two (2) years commencing on the date of original purchase and will, at its option, repair or replace, free of charge, any part found to be defective in material or workmanship. [. . . ]