User manual MTD 3016G SERVICE MANUAL

[. . . ] GROUNDING INSTRUCTIONS This tool should be grounded while in use to reduce the risk of electric shock to the operator. The tool is equipped with a 3-conductor cord and 3-prong grounding plug to fit the proper grounding receptacle. The green or green and yellow wire to live terminal. If your unit is for use on less than 150 volts, it has a plug as illustrated in sketch A in Figure 1 on page 2. [. . . ] Extension cords of the type specified above are available at local hardware stores. Extension cord-Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized extension cord will cause a drop in line voltage resulting in loss of power and overheating. Table 1 shows the correct size to use depending on cord length and nameplate ampere rating. To reduce the risk of disconnection of appliance cord from the extension cord during operating: Make a knot as shown in Figure 2; Volts Avoid dangerous environment. Water entering a power tools will increase the risk of electric shock. Never yank it to disconnect from receptacle. Keep cord away from heat, oil, sharp edges or moving parts. All visitors should be kept at a distance from work area. Use of rubber gloves and substantial footwear is recommended when working outdoors. We recommend wide Vision Safety Mask for use over eyeglasses or standard safety glasses with side shields. mETAL SCREW COVER OF GROUNDED DUTLET BOX ADAPTER WEAR YOUR SAFETY GLASSES AND DUST MASK HOW TO ASSEMBLE YOUR TRISECTA 1. Push the large diameter section of the axle into the axle tube and secure the axle into position using the M8 x 40 hex screws and star washer. Push the wheel and then the 12mm flat washer over the axle. Push the split pin through the hole in the end of the axle and bend the ends over using pliers. 1 Total length of cord in feet 25 50 100 150 PRECAUTIONS FOR USING TRISECTA WARNING: Extreme caution should be taken to ensure shreddable material does not contain metal. Do not allow hands or any other part of the body, or clothing to enter inside the feeding chambers or discharge chute, while machine is operating. € • • • • • Wear gloves while operating the machine. Before starting the machine, ensure that all screws and other fasteners are properly secured. Machine should be operated on firm level surfaces only. Before starting the machine, check that the cutting chamber is empty. [. . . ] Do not overfeed and do not feed wet, soggy material into the Trisecta as this may clog the blade chamber and the discharge chute. Carefully remove all parts from the shipping carton. Do not discard material until you have identified all the parts using the parts list. if all parts have been included proceed to assembly. [. . . ]