User manual MTD 34344 PART LIST

[. . . ] The unit shall not be exposed to dripping or splashing. Do not place any sources of danger on the unit (e. g. liquid filled objects, lighted candles). Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. Warning •• Never remove the casing of this unit. [. . . ] f Slider • Stabilize the mobile phone while charging. h - TUNING + • Tune to FM radio stations manually. 5 EN o PROG • Program the play sequence of tracks. • Program FM radio stations. p q r • Open or close the compartment. • Erase a program. 3 Get started Always follow the instructions in this chapter in sequence. Connect power The system can be powered by either AC power or batteries. Option 1: Battery power Caution •• Batteries contain chemical substances, so they should be disposed of properly. Note •• Batteries are not supplied with the accessories. 1 2 3 Open the battery compartment. Insert 6 batteries (type: R14/UM2/C CELL) with correct polarity (+/-) as indicated. Close the battery compartment. EN 6 Option 2: AC power Warning supply voltage corresponds to the voltage printed on the back or the underside of the system. When you disconnect the AC power, always pull the plug from the socket. Never pull the cord. •• Risk of product damage!Make sure that the power Connect the AC power cord to: • the AC~ MAINS socket on the back of the system. • the wall outlet. Tip •• To save energy, turn off the system after use. Note •• In USB or Bluetooth mode, if the system is idle for 15 minutes, it switches to standby mode automatically. To exit the standby mode, press . Turn off Switch the power slide to the OFF position. »» After successful pairing and connection, the system beeps twice. »» Audio streams from your device to this system. Connect an audio cable (3. 5mm, not supplied) to: • the AUDIO IN socket inside the compartment. • the headphone socket on an external device. »» The system switches to Audio-in mode automatically. 4 To disconnect the Bluetooth-enabled device: • Deactivate Bluetooth on your device; or • Move the device beyond the communication range. To clear Bluetooth pairing history: Press and PROG together for 3 seconds. »» The current Bluetooth connection is disconnected. »» After successful clearing, [CLR] (clear) blinks for 5 seconds, then [-] scrolls on the display. 3 Play audio on the external device (see the user manual of the device). 9 EN 5 Listen to FM radio Tune to FM radio stations Note •• For better reception, fully extend and adjust the position of the FM antenna. 3 4 Press PRESET + or PRESET - to allocate a number (1 to 20) to this radio station, then press PROG to confirm. »» The preset number and the frequency of the preset station are displayed. Repeat the above steps to store other stations. Note •• To remove a pre-stored FM radio station, store another station in its place. 1 2 3 Rotate the source selector to the FM position. »» The system tunes to a station with strong reception automatically. Repeat step 2 to tune to more stations. Select a preset radio station In FM tuner mode, press PRESET + or PRESET - to select a preset radio station. To tune to a radio station manually: Rotate the tuning knob slowly. Store radio stations automatically In tuner mode, press and hold PROG for 2 seconds. [. . . ] If the problem remains unsolved, go to the Philips Web page (www. philips. com/support). When you contact Philips, make sure that the device is nearby and the model number and serial number are available. No power •• Ensure that the AC power plug of the unit is connected properly. •• Ensure that there is power at the AC outlet. [. . . ]