User manual MTD Z-WING 48

[. . . ] Hydrostatic Zero-Turn Commercial Riding Mower Professional Turf Equipment Z - Wing 48 OPERATOR’S AND SERVICE MANUAL TABLE OF CONTENTS Foreword. Zero Turn Break-In and Operating Procedures . Deck Corner Ball Wheel Roller Settings . Deck Center Anti-Scalp Roller Settings . [. . . ] Please be aware of the environment when disposing of used oil. 4. Changing the Spindle Assembly a. Jack up the front of the mowing deck about one foot and block it in that position. Make sure the blade clutch is disengaged. Using a wrench or socket rachet remove four hex nuts, and the four hex head cap screws. Remove the spindle assembly. B. Hydraulic Oil WARNING: Never overfill the hydraulic units. Damage can occur if the oil level is not within the proper operating range. Note: When adding hydraulic oil, do so in small quantities and recheck the oil level before adding more. It is important that you do not overfill the reservoir. a. Place the Mower on a level surface and engage the parking brake. Stop the engine and remove the key from the ignition switch. Raise the seat forward to expose the hydraulic oil fill point. Clean the area around the hydraulic fill oil cap. Place a suitable container (at least 2 quarts) under the hydraulic reservoir and filter. Remove the hydraulic filter to allow hydraulic oil to drain. Remove the drain plug from the bottom of the hydraulic oil tank to drain. Place a small pan under the pump motor frame. Remove fill oil cap from hydraulic reservoir for faster drainage. Remove nut 16 caps and drain oil from both left and right pumps. Replace and retighten nuts. Hydraulic pumps c. Store the battery with a full charge. A discharged battery will freeze (refer to the table below). Specific Gravity 1. 265 1. 250 1. 200 1. 150 1. 100 Unfasten hose and drain from this side of both pumps. Freezing Temp (°F) -71 -62 -16 5 16 Figure. Recharge battery when ever the specific gravity value is less than 1. 225 3. Battery Removal j. Coat new filter seal with oil before installation. Install new hydraulic oil filter filled with new oil. [. . . ] Operate ZERO-TURN mowers across the face of slopes, never up and down slopes. Operate WALK-BEHIND mowers across the face of slopes, never up and down slopes. 29 MAINTENANCE RECORD DATE WORK PERFORMED DATE WORK PERFORMED 30 MAINTENANCE RECORD DATE WORK PERFORMED DATE WORK PERFORMED 31 MANUFACTURER’S LIMITED WARRANTY - TURF EQUIPMENT This warranty is specific to the product manual to which it is attached. For a complete list of products and warranties contact your authorized Cub Cadet Commercial dealer. Proper maintenance of the purchased Cub Cadet Commercial equipment is the owner’s responsibility. [. . . ]