User manual MTD ZERO-TURN

[. . . ] Hydrostatic Zero-Turn Commercial Riding Mower Professional Turf Equipment 60” Fabricated Deck W/ R. O. P. S. OPERATOR’S AND SERVICE MANUAL TABLE OF CONTENTS Foreword. Zero Turn Break-In and Operating Procedures . Deck Corner Ball Wheel Roller Settings . Deck Center Anti-Scalp Roller Settings . [. . . ] Remove ignition key and both spark plug caps. Unscrew the wing nuts from the deck covers and remove both covers. Using a 1/2" socket breaker bar or socket rachet insert the male end into the 1/2" opening in the lower idler arm assembly and pull the idler arm clockwise. While holding the idler arm back, loosen the blade drive belt from the pulley and slide the belt away from the pulley. Remove tension of the PTO belt by moving the belt tensioning rod. Loosen the belt retaining bolt. 16 Cover Plate Spindle Figure. Pull the tensioner pulley away from the belt and remove the PTO belt then remove the blade drive belt. Reverse the process to install the belt. Hydraulic Tank Note: When replacing belts do not overtighten. Adjust the idler pulley so that a tenpound pull with a spring scale between two pulleys deflects the belt about 1/2". Adding Hydraulic Oil (use SAE20W 50) Place the Mower on a level surface and engage the parking brake. Stop the engine and remove the key from the ignition switch. Clean the area around the Hydraulic Oil fill neck. Remove the hydraulic fill cap and check the level. The correct level is up to the lowest hole of the oil tank fill neck. Pour hydraulic oil into the reservoir up to the lowest hole in the oil tank fill neck, if necessary. a. 4. Changing the Spindle Assembly a. Jack up the front of the mowing deck about one foot and block it in that position. Make sure the blade clutch is disengaged. Using a wrench or socket rachet remove four hex nuts, and the four hex head cap screws. Draining Hydraulic Oil Used hydraulic oil must be disposed of properly. Do not pour it down a drain or sewer, or dump it on open land, this creates an environmental hazard. Please be aware of the environment when disposing of used oil. B. Hydraulic Oil WARNING: Never overfill the hydraulic units. Damage can occur if the oil level is not within the proper operating range. Note: When adding hydraulic oil, do so in small quantities and recheck the oil level before adding more. [. . . ] 12) Height of Cut LInk Eyebolt Point B Eyebolt Point D Point A Jam Nuts Figure. 12 Point C 27 WIRING DIAGRAM 28 MAINTENANCE RECORD DATE WORK PERFORMED DATE WORK PERFORMED 29 MAINTENANCE RECORD DATE WORK PERFORMED DATE WORK PERFORMED 30 MAINTENANCE RECORD DATE WORK PERFORMED DATE WORK PERFORMED 31 MANUFACTURER’S LIMITED WARRANTY - TURF EQUIPMENT This warranty is specific to the product manual to which it is attached. For a complete list of products and warranties contact your authorized Cub Cadet Commercial dealer. Proper maintenance of the purchased Cub Cadet Commercial equipment is the owner’s responsibility. [. . . ]