User manual MTD CADET EX

[. . . ] 1 of 15 INSTALLATION & OWNER’S MANUAL cab kit with hard doors and soft rear curtain p/n 59A40058727 An optional Hard Rear Panel can be purchased separately. The contents of this envelope are the property of the owner. Be sure to leave with the owner when installation is complete. APPROXIMATE INSTALLATION TIME: 2 to 3 HOURS (excluding accessories) Shown with optional work lights and optional sliding windows in doors. Additional options available are: heater, hard rear panel, and rear window wiper. [. . . ] Bulb rubber to all be pointing outward as shown. 6. 2, use the following hardware per side: in the very top hole, use one 5/16-18 button head bolt, two steel washers, and one locknut. Locknut to be underneath the welded mounting tab on the side frame. Note: no nylon washer required on this top bolt. 6. 2, the very bottom hole on the cowl will use the following hardware and thread into a factory installed threaded insert: one 5/16-18 x 3/4” long button head bolt, one plastic washer, and one steel washer. 6. 2, the middle hole will use the following hardware: one 5/16-18 x 3/4” long button head bolt, one plastic washer, two steel washers, and one locknut. bulb rubber to be pointing outward as shown Fig. 6. 1 (view from right front side of tractor) 7. Have the following items ready: four 5/16-18 x 1 3/4” long flat head bolts, 4 steel washers, 4 locknuts, and 2 plastic spacer blocks. With assistance, install the windshield hinges to the windshield support with the two spacer blocks between the hinge and the windshield support. Attach windshield latches to windshield latch receivers on the cowl by squeezing tabs to retract spring loaded pins. Lift up on bottom of windshield and close latches. Check alignment of windshield with side frames and tighten hinge hardware. use plastic washers here no plastic washer required here Fig. 6. 2 (view from right front side of tractor) sandwich the plastic spacer block here latch receiver Fig. 7. 1 (view from right front side of tractor) Fig. 7. 1. 1 (view from left rear side of tractor) Rev. 8 of 15 8. ROOF 8. 1 If installing an optional hard rear panel, remove the six soft rear curtain snaps pre-assembled onto the back surface of the roof. 8. 2 Use a Phillips head screwdriver to punch a hole through the headliner at all of the covered bolt hole locations (10 places). Punch holes from the inside out to avoid having the headliner pull away from its glued surface. 8. 3 With assistance, install the roof oriented so the reflectors are towards the rear of the tractor. If installing an optional hard rear panel, the back of the roof must go over the tops of the rear legs and the rear window panel so they are contained. [. . . ] FINISHING TOUCHES 16. 1 Install the gas shock to the frame and door with the small piston end towards the door. Press the button on the compression fastener to lock the gas shock to the ball stud. 16. 2 Install the supplied 5/16” nut covers (qty. : 20) on the interior hex locknuts by snapping over nut. Install the two 1/4” nut covers on the locknuts for the vibration mounts. [. . . ]