User manual MTD 6032-1

[. . . ] Read the whole manual and follow all the instructions to keep your new outdoor power tool in top operating condition. 7 PRODUCT REFERENCES, ILLUSTRATIONS AND SPECIFICATIONS All information, illustrations and specifications in this manual are based on the latest product information available at the time of printing. We reserve the right to make changes at any time without notice. Inside Back Cover SERVICE INFORMATION Service on this unit both within and after the warranty period should be performed only by an authorized and approved service dealer. [. . . ] Place the unit in the starting position (Fig. Move the throttle control to the fast position ( ) (Fig. Pull the starter rope briskly 5 times while still in the FULL choke ( ) position. If the engine attempts to run before the fifth pull, proceed to Step 7. NOTE: The engine won’t run in the FULL choke ( ) position. Place the choke lever in the PARTIAL choke ( position (Fig. Pull starter rope briskly 1 to 3 times to start the engine (Fig. If the engine does not start, repeat steps 3 through 8. NOTE: If the engine floods while trying to start, place the choke lever in the RUN ( ) position (Fig. Move the throttle control to the fast position ( ) (Fig 9). The engine should start with three (3) to eight (8) pulls. € Always hold the unit with both hands when operating. Keep a firm grip on both the front and rear handle or grips. € To reduce the risk of hearing loss associated with sound level(s), hearing protection is required. € Operate power equipment only at reasonable hours— not early in the morning or late at night when people might be disturbed. comply with times listed in local ordinances. Usual recommendations are 9:00 am to 5:00 pm, Monday through Saturday. Set the blower/vacuum mode change-over lever to the up position (Blower Mode) (Fig. NOTE: Never use the unit with the lever in a position half way between either mode. If you are using the optional shoulder harness, place it over your head and onto your shoulder and adjust it. Sweep from side to side with the nozzle several inches above the ground or floor. Slowly advance the unit, keeping the accumulated pile of debris in front of you. [. . . ] € Any manufacturer approved replacement part may be used in the performance of any warranty maintenance or repair of emission related parts and will be provided without charge to the owner. Any replacement part that is equivalent in performance or durability may be used in non-warranty maintenance or repair and will not reduce the warranty obligations of the manufacturer • The following components are included in the emission related warranty of the engine, air filter, carburetor, primer, fuel lines, fuel pick up/ fuel filter, ignition module, spark plug and muffler. 21 MANUFACTURER’S LIMITED WARRANTY FOR: The limited warranty set forth below is given by MTD LLC (“MTD”) with respect with new merchandise purchased and used in the United States, its possessions and territories. MTD warrants this product against defects in material and workmanship for a period of two (2) years commencing on the date of original purchase and will, at its option, repair or replace, free of charge, any part found to be defective in material or workmanship. [. . . ]