User manual MTD 120-190A

[. . . ] This modern outdoor power tool will provide many hours of useful service. You will find it to be a great labor-saving device. This operator’s manual provides you with easy-to-understand operating instructions. Read the whole manual and follow all the instructions to keep your new outdoor power tool in top operating condition. [. . . ] Pull starter rope briskly 1 to 3 times to start the engine (Fig. NOTE: Squeeze the throttle control until the engine has started and warmed up. If the engine does not start, repeat steps 3 through 7. Squeeze the throttle control to warm up the engine for 5 to 10 seconds. Place the choke lever in the RUN (C) position (Fig. Start the unit in the PARTIAL choke (B) position (Fig. After starting, place the choke lever in the RUN (C) position (Fig. Release your hand from the throttle control (Fig. Allow the engine to cool down by idling. Put the On/Off Stop Control in the OFF (O) position (Fig. Throttle Control 9 OPERATING INSTRUCTIONS HOLDING THE TRIMMER WARNING: Always wear eye, hearing, foot and body protection to reduce the risk of injury when operating this unit. Rotate the whole unit so that the cutting attachment is at a 30° angle to the ground (Fig. 11 Each time the head is bumped, about 1 inch (25. A blade in the cutting attachment shield will cut the line to the proper length if any excess line is released. For best results, tap the bump knob on bare ground or hard soil. If you attempt a line release in tall grass, the engine may stall. Always keep the trimming line fully extended. Line release becomes more difficult when the cutting line gets shorter. 10 MAINTENANCE & REPAIR INSTRUCTIONS MAINTENANCE SCHEDULE Perform these required maintenance procedures at the frequency stated in the table. These procedures should also be a part of any seasonal tune-up. NOTE: Some maintenance procedures may require special tools or skills. If you are unsure about these procedures take your unit to any nonroad engine repair establishment, individual or authorized service dealer. [. . . ] € In order to file a claim, go to your nearest Authorized Troy-Bilt Service Center. warranty services or repairs will be provided at all Authorized Troy-Bilt Service Centers. € Any manufacturer approved replacement part may be used in the performance of any warranty maintenance or repair of emission related parts and will be provided without charge to the owner. Any replacement part that is equivalent in performance or durability may be used in non-warranty maintenance or repair and will not reduce the warranty obligations of the manufacturer • The following components are included in the emission related warranty of the engine, air filter, carburetor, primer, fuel lines, fuel pick up/ fuel filter, ignition module, spark plug and muffler. [. . . ]