User manual MTD C-2

[. . . ] Your new International Harvester rotary mower is designed to meet today's exacting operating requirements. The ease of operation and ability to adjust to field conditions lighten your work and shorten your hours on the job. You are urged to consult your International Harvester dealer concerning unusual field conditions or special applications. Let the experience of your dealer and the organization associated with him serve you. Be sure to read the instructions for Adjusting and Operating in this manual. Check each item referred to and acquaint yourself with the adjustments required to obtain efficient operation and maximum trouble-free performance. [. . . ] The tractor requires the use of a belt pulley gear box (not furnished with the mower) and is to be mounted next. Refer to the tractor Operator's Manual for instructions. SeeIllust. Secure the lift angles to the rear pivot bars with four 1/2 x 1-1/4 inch hex. head cap screws, lock washers, and nuts. When installing a new mower, use the second and third holes from the rear of the angle. Insert the two 1-1/32 x 1-1/2 inch x 11 ga. washers over the belt pulley drive shaft. Install the splined hub on the shaft, then position the drive sheave around the splined hub and secure with three 1/4 x 1-1/8 inch hex. Tighten the platform cap screws previously left loose. Reposition platform runners in top two holes. 8. Attach the lift chain arm to the inside of the tractor right rockshaft arm, using two 5/8 x 1-3/4 inch hex. head cap screws, lock washers, and nuts. Attach the lift chain to this arm and to each lift angle, using a 3/8 x 1 inch hex. head cap screw, flat washer, lock washer, and nut. Install the drive belt around the idlers, platform drive sheave, and rear drive sheave. Note: The belt extends from the flat idler to the right hand side of the platform drive sheave. Position the platform assembly under the tractor. Attach the lift angles to the platform with eight 1/2 x 1-1/4 inch hex. head cap screws, flat washers, lock washers, and nuts. Note: The leg of the angle that bolts to the platform must extend inward toward the spindle. llA. 10 Illust. SETTINGUP FARMALL CUB TRACTOR (With Fast-Hitch) -Continued Il/ust. 118 Illust. llA For correct belt tension the platform must be in a down position. [. . . ] head cap screw, lock washers, and nuts for each arm. Mount the wheel and wheel arm assemblies to the tail wheel arms with 1/2 x 1-3/4 inch clevis pin, flat washer, and 5/32 x 1 inch cotter pin. This completes the assembly; the mower is now ready to be mounted to the tractor. FarmallCubTractor: Reverse the diagonal link to allow mounting of the universal drive. See Illust. [. . . ]