User manual MTD EB356A

[. . . ] STOP ARRÊT ALTO USER MANUAL For problems or questions, DO NOT return this product to the store. Hold chain saw firmly with both hands when using. For your own safety, please read and follow the safety precautions in this manual before attempting to operate your chain saw. pN 9096-311202 Printed in Taiwan INTRODUCTION PLEASE READ Dear Customer , Thank you for purchasing a McCulloch product. [. . . ] Place the saw on a firm and level surface. Hold the saw securely with your foot as illustrated. 5-2E) NOTE: If the engine sounds as if it wants to start before the 4th pull, end the tugging of the starter and proceed as described in the next step. Push in the choke (E) as far it will go. Hold the saw securely and tug sharply on the starter 4 times. Let the engine run for 10 seconds to warm up. Press the trigger (F) and put it into idle. If the engine does not start up, repeat the above steps. 5-2B C 5-2C Gasoline and Oil Mix 40:1 D 5-2D 5-2E Oil Only E F 5-2F 5-2G IMPORTANT IDLING INFORMATION In some cases due to operating conditions (altitude , temperature etc. ) your chain saw may need a slight adjustment to the idle speed. After warm up - See the User's Manual section 5-2, step 7 - If unit does not Idle after restarting 2 times, follow these steps to adjust idle. FUEL Use regular grade unleaded gasoline mixed with Genuine Factory Parts 40:1 custom 2-cycle engine oil for best results. Never use straight gasoline in your unit. This will cause permanent engine damage and void the manufacturer’s warranty for that product. Never use a fuel mixture that has been stored for over 90 days. If 2-cycle lubricant other than Genuine Factory Parts Custom Lubricant is to be used, it must be a premium grade oil for 2-cycle air cooled engines mixed at a 40:1 ratio. Do not use any 2-cycle oil product with a recommended mixing ratio of 100:1. If insufficient lubrication is the cause of engine damage, it voids the manufacturer’s engine warranty for that occurrence. ENGINE PRE-START CHECKS FUEL MIXING TABLE WARNING Never start or operate the saw unless the bar and chain are properly installed. Fill the fuel tank (A) with correct fuel mixture (Figure 5-1A). Fill the oil tank (B) with correct chain and bar oil (Figure 5-1A). Be certain the CHAIN BRAKE® is disengaged (C) before starting unit (Figure 5-1A). [. . . ] WARNING Wear heavy duty work gloves when handling the bar and chain. NOTE: It is not necessary to remove the saw chain to lubricate the guide bar sprocket tip. Using the Lube Gun (optional), insert tip of lube gun into the lubrication hole and inject grease until it appears at outside edge of sprocket tip (Figure 8-1A). Repeat lubrication procedure until the entire sprocket tip has been greased. [. . . ]