User manual MTD EB428

[. . . ] USER MANUAL STOP ARRÊT ALTO For problems or questions, DO NOT return this product to the store. Hold chain saw firmly with both hands when using. For your own safety, please read and follow the safety precautions in this manual before attempting to operate your chain saw. pN 9096-MD0707 Printed in Taiwan INTRODUCTION PLEASE READ Dear Customer , Thank you for purchasing a McCulloch product. [. . . ] Fill the oil tank (B) with correct chain and bar oil (Figure 5-1A). Be certain the CHAIN BRAKE® is disengaged (C) before starting unit (Figure 5-1A). - If unit does not Idle after restarting 2 times, follow these steps to adjust idle. Using a Phillips or slotted screwdriver - turn screw 1/4 to 1/2 turn clockwise (to the right). (Figure 5-2H) NOTE: If chain turns while idling - turn screw back to the left until chain stops and unit continues to idle. RECOMMENDED FUELS Some conventional gasolines are being blended with oxygenates such as alcohol or an ether compound to meet clean air standards. Your McCulloch engine is designed to operate satisfactorily on any gasoline intended for automotive use including oxygenated gasolines. MIXING FUEL Mix fuel with Genuine Factory Parts brand 2 cycle oil in an approved container. Use mixing table for correct ratio of fuel to oil. CHAIN AND BAR LUBRICATION Always refill the chain oil tank each time the fuel tank is refilled. We recommend using Genuine Factory Parts Chain, Bar and Sprocket Oil, which contains additives to reduce friction and wear and to assist in the prevention of pitch formation on the bar and chain. Pull the blue lever (D) out as far as it will go until the blue lever stays out (Fig. This advances the throttle so you do not have to hold the trigger while starting. Fully press and release the primer bulb (E) 10 times, slowly. Some amount of fuel should be visible in the primer bulb (Fig. If you can’t see fuel in the bulb, press and release the bulb as many times as it takes before you can see fuel in it. Pull the rope with a controlled and steady motion 4 times. Then move the blue lever (F) all the way in (Fig. NOTE: The unit uses Smooth Pull™, which significantly reduces the effort required to start the engine. You must pull the starter rope out far enough to hear the engine attempt to start. There is no need to pull the rope briskly-- there is no harsh resistance when pulling. Be aware that this starting method is vastly different from (and much easier than) what you may be used to. [. . . ] WARNING Wear heavy duty work gloves when handling the bar and chain. NOTE: It is not necessary to remove the saw chain to lubricate the guide bar sprocket tip. Using the Lube Gun (optional), insert tip of lube gun into the lubrication hole and inject grease until it appears at outside edge of sprocket tip (Figure 8-1A). Repeat lubrication procedure until the entire sprocket tip has been greased. [. . . ]