User manual MTD FRONT SWEEPER FASTATTACHTM 48, 49, 500, 600, 700

[. . . ] 10 Removal. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Storage / Not in use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Spare parts list . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Only use original spare parts or spare parts which have been approved by the manufacturer. Technical data Width: Height without guide: Length (without sweepings container): Weight: Sweeping width: Brush diameter: 1000 mm 480 mm 880 mm 48. 5 kg 1000 mm 330 mm Warranty The warranty conditions issued by our company or. We rectify defects on your machine according to the warranty conditions at no charge provided the cause can be attributed to material or manufacturing defects. In the case of a warranty claim, please contact your sales representative or the nearest subsidiary. 5 Operating Manual FK 105 Mounting Preparing the lawn tractor for mounting the front sweeper For technical safety reasons, a cable bridge according to the instructions below must be installed for the attachment of the sweeper. The installed cable bridge between brake switch and seat safety switch ensures that the engine always automatically switches off as soon as the operator leaves the driver's seat. Open the engine cover and if necessary remove the right-hand side panel and / or the fuel tank (depending on the design) in order to access the cable harness. Open the black cable harness sheath from the wiring harness to the ignition switch (underneath the fuel tank) and Fuel tank expose the yellow cable. removed Electrical accessories: A = vehicle cable 1. 5 mm² B = branch connector, blue C = cable tie 1. 2. 3. Connect cable "A" to the yellow cable with a branch connector "B" A B 6 Operating Manual FK 105 4. Open the black cable harness sheath from the wiring harness to the brake switch (between step and frame) and expose the yellow/white cable. right footboard 5. Connect the free end of cable "A" to the yellow/white cable with a branch connector "B". A B 6. Press all the cables back into the cable harness sheath and fasten the cable "A" in parallel with the cable harness using 3 cable ties. Replace right-hand side panel and/or fuel tank (depending on design). It is necessary to limit the lift-up height of the mower deck due to the additional V-belt pulley under the engine. An M12x25 bolt with 2 large washers and a lock nut are mounted on the lever connecting link for this. 7 Operating Manual FK 105 9. squared timber so that the strain relief clamp on the front side of the deck is not stressed. Unbolt the strain relief clamp from the cross member "D" on the front of the machine and replace it with the supplied deck suspension "E". Re-adjust the tension distance according to the original strain relief clamp. D View from front right E 11. Undo the fixing bolt of the engine V-belt pulley. Position the supplied V-belt pulley "F" so that the pins on the spanner flats of the coupling nut act as drivers. Fix everything with the whitworth bolt also supplied. Perform a test run and functional check - ensure that the engine always stops automatically as soon as the operator leaves the driver's seat. 8 Operating Manual FK 105 ___________________________________________________________________________ 13. [. . . ] After a slight resistance, the lowering occurs slowly. M 2. For swivelling the brush deck, hold the handle of the extension tube of the swivel rod "O", lift it upwards and move it forwards or backwards in order to swivel to the left or to the right. The locking comb "S" locks the respective position when you release the bar. Silentblock 6kt-Schraube M6x20 Stopmutter M6 Bürstenmitnehmer 44 Mitnehmerstab Bürstenachse 1m Scheibe Bürstenträger M1 K-Führung MD Endet eine Art. -Nr. mit einer angehängten "1", so ist die VE = 10 St. 15 Operating Manual FK 105 MTD FK 105 63 64 Spare Parts List 66 67 66 64 Tafel 2 63 65 61 65 62 68 69 70 74 71 79 92 81 80 67 71 70 91 72 72 71 70 76 75 78 73 84 83 85 87 88 67 79 101 102 103 104 93 94 82 79 77 86 90 89 88 105 108 109 84 111 110 84 85 99 98 106 107 100 97 96 95 16 Operating Manual FK 105 MTD FK 105 Pos. [. . . ]